Dancing Wings Hobby SCG34 Kullanım Kılavuzu - Sayfa 6

Hava Araçları Dancing Wings Hobby SCG34 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Dancing Wings Hobby SCG34 8 sayfaları. Balsawood scale airplane

Sayfayı Yazdır

机翼拉线安装

Installation

机翼拉线以一边为例，左右相同安装。

Installation for the wing bracing wire

Take the one side wing bracing wire as an example, the left and right installation in same method.

机翼拉线为上下各两根钢丝绳，从1起如图穿过2在3处止，钢丝绳两端点用铝扣打结。

There are each 2pcs steel bracing wires up and down, start at "1" as above picture

shown,

pass through "2",until end at "3".Use alu buckle to tie a knot on both ends.

自攻螺丝

Self-tapping screw

M3x10mm

引擎安装示范

Assemble the engine

调整安装好引擎后，调整前起落架伸出长度，调整到不干涉桨叶止，然后在图示螺丝位置钻孔，最后用螺丝固定起落架。

After installation and adjustment of engine, adjust the extension length of landing gear,

until without influence for propeller, then drill holes on the screw position as shown, fasten the landing gear with screw lastly.

螺丝M3*15mm+螺母

Screw +nut

防火墙四周，用三角木加固，用环氧胶粘固。

Strengthen the firewall with triangle wood around and

stick with epoxy glue.

F25

F25-2

F25-1