Duevi RX2 AP Kullanım Kılavuzu - Sayfa 3

Alıcı Duevi RX2 AP için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Duevi RX2 AP 4 sayfaları. 2 channels wireless receiver

3. "ONLY REMOTE CONTROLS" MODE

(jumper C13 closed)

In this working mode, the TXS remote controls are the only device that is considered by the receiver.

Even if other devices are allowed to be programmed, that devices will be completely ignored by the

receiver. It is possible to program up to 10 TXS remote controls, selecting than with the jumper JP3 the

working mode of both the channels (RL1 and RL2).

JP3 closed = BISTABLE OUTPUTS

Pressing Red Key, the RL1 is armed – Pressing again the RL1 is disarmed

Pressing Green Key, the RL2 is armed – Pressing again the RL2 is disarmed

JP3 open = IMPULSIVE OUTPUTS

Pressing Red Key, the RL1 is armed and after 2 seconds automatically disarmed

Pressing Green Key, the RL2 is armed and after 2 seconds automatically disarmed

4. SENSORS MODE

(jumper C13 open)

In this working mode it is possible to use both sensors and remote controls, selecting with the jumper JP3 the

working mode of the Channel 1 (RL1) with remote controls.

JP3 closed = RL1 BISTABLE OUTPUT

Pressing Red Key the RL1 is armed – Pressing Green Key the RL1 is disarmed

JP3 open = RL1 IMPULSIVE OUTPUT

Pressing any key of the remote control the RL1 is armed and after 2 seconds automatically disarmed

IMPORTANT NOTICE: The working mode of the relay outputs (RL1 and RL2) with the SENSORS is

always IMPULSIVE, even if JP3 is closed. For every transmission of sensor, the receiver will arm the

corresponding output relay and than disarm after 2 seconds.

5. TSR MODE

It is possible to use the reciever also with the 48bit TSR (Siren transmitter). To program the TSR code it is

sufficient to press the tx tamper button on the TSR.

The receiver works in different modes, depending on the setting of the jumper JP3.

JP3 closed = BISTABLE OUTPUTS

Channel1 (RL1) is armed when TSR transmits an "ARM" code, disarmed when it transmits a "DISARM" one.

Channel2 (RL2) is armed for 2 seconds when TSR transmits an "ALARM" code

JP3 open = IMPULSIVE OUTPUTS

Channel1 (RL1) is armed for 2 seconds when TSR transmits an "ALARM" code

Channel2 (RL2) is armed for 2 seconds when TSR transmits a "DISARM" code

IMPORTANT NOTICE

The RX2AP receiver works properly

ONLY with the new family of device with suffix 100;

for example CTSR-100 / DIRRV-100 / TXS-100 etc.

RX2AP V2.4

This manual can be modified without any advice