Dancover CT168020 Manuel - Sayfa 5

Çadır Dancover CT168020 için çevrimiçi göz atın veya pdf Manuel indirin. Dancover CT168020 7 sayfaları. Bell tent

4: Adjust the pole so it stands in an upright position. This should be ok to leave

standing by itself supporting the Tent.

Get the A frame entrance poles (undone) and enter the tent.Once in, click

them into place and put the metal spike on the top of the A frame through the

matching hole in the canvas above the door. Now move the A frame forwards

into the door space until it is upright. (There are places either side of the door

to keep the poles in situ.)

The first time you use the tent you will have to attach the guy ropes to the

canvas loops at the bottom end of the roof. After this they can be left attached

in place for your next trip.

: 7

Zip the door shut and, using the large pegs, attach the first guy rope above

the door. Then do the guy ropes around the whole tent without putting any of

them under too much tension.

N.B. All the guy ropes need to follow the lines of the seams in the roof. Adjust

the guy rope slider so you have approx 50cm of loop to the peg.This allows

adjustment in both directions.It is important to make sure the Bell Tent stays

symmetrical and that the tension is evenly spread.