Cascade 100K Kullanıcı Kılavuzu - Sayfa 7

Forkliftler Cascade 100K için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Cascade 100K 20 sayfaları. Fork positioner/sideshifter
Ayrıca Cascade 100K için: Kurulum Talimatları Kılavuzu (10 sayfalar)

Sayfayı Yazdır

RUCK REQUIREMENTS

Truck Relief Setting

152 bar Recommended

241 bar Maximum

Truck Flow Volume

55K, 65K

100K, 120K,

150K, 165K

➀ Cascade K-Series Fork Positioner/Sideshifters are compatible with

SAE 10W petroleum base hydraulic fluid meeting Mil. Spec. MIL-0-

5606 or MIL-0-2104B. Use of synthetic or aqueous base hydraulic

fluid is not recommended. If fire resistant hydraulic fluid is required,

special seals must be used. Contact Cascade.

➁ Flow less than recommended will result in slow fork positioning

speed.

➂ Flow greater than maximum can result in excessive heating,

reduced system performance and short hydraulic system life.

Carriage Mount Dimension (A)

Class II

Class III

Class IV

GA0028.eps

Auxiliary Valve Functions

Check for compliance with

ISO standards:

GA0082.eps

6055911-R8 EN

➀

Min.

➁

Recommended

4 L/min.

7.5 L/min.

4 L/min.

16L/min.

Minimum

380.0 mm

474.5 mm

595.5 mm

Tilt

Sideshift

Forward

Left

Open

Forks

Hoist Down

Hoist Up

Tilt

Sideshift

Back

Right

Max.

➂

12 L/min.

20 L/min.

ISO

Carriage –

Maximum

bars. Assure that bars are parallel and that

381.0 mm

ends are flush. Grind smooth any protruding

476.0 mm

welds that may affect sideshifter lower

597.0 mm

bearings. Repair any damaged notches.

WARNING:

attachment function activation shown here

conforms to ISO 3691 ANSI/ITSDF B56.1

recommended practices. Failure to follow

these practices may lead to serious bodily

injury or property damage. End user, dealer

and OEMs should review any deviation from

the practices for safe operation.

Forks

GA0131.eps

Clean and inspect carriage

Truck control handle and