Dancover Semi Pro XL 6m Series Montaj Talimatları Kılavuzu - Sayfa 8

Çadır Dancover Semi Pro XL 6m Series için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. Dancover Semi Pro XL 6m Series 8 sayfaları. Pvc-tent

Sayfayı Yazdır
Instructions
Select a flat surface for the tent. Unpack the boxes and check if all listed parts are included.
with a cloth. In colder weather conditions we suggest to bring the roof to room temperature before installing.
1
Assemble the roof frame by mounting parts 10 to 15 on the pipes (parts 1, 2,and 3).
Use the screws 22 to attach the parts.
2
Attach the reinforcement braces (parts 4 and 5) using screws (23) and wing nuts (26).
3
Lift one side of the tent frame and attach the legs (7). Attach the legs with part no. 8 to the outside in all four corners. Place the
roof (32) onto the frame and use the bungees (28) to fasten it. Be sure not to put too much tension on the bungees in order not
to make attaching the other side more difficult.
4
Attach the legs on the other side and install the feet (16, 17) at the bottom.
to avoid overtention on the endwalls.
the diagonal pipes (6) to all four corners. Complete the bottom frame with the required pipes (2 and 9) and connector (18).
Use the big ground pegs (19) to fasten the feet to the ground.
5
Unfold the side walls (33) and the end walls (34) and attach the side walls to the frame using the bungees (28). Attach the end walls
directly to the roof using the short bungees (29). Use the short ground pegs (21) to fasten the end walls to the ground. The guy rope
runs from every corner of the tent and is braced to the ground using the ground pegs.

Cleaning and maintenance

Wash off the roof and the side parts with soapy water. Mould and mould stains can be removed using a mild
chlorine solution. Observe the instructions provided by the manufacturer and test the chlorine solution on a
hidden spot to make sure that there is no discolouration.
Caution! The party tent must not be
Caution
1. Always handle the tent with care to avoid damage.
2. Do not apply too much pressure to the frame parts to avoid damage.
3. Tents are intended for temporary accommodation and should be taken down in adverse weather
conditions.
4. Always be sure to keep sufficient distance to hoses as well as gas and power lines to avoid possible
damage.
5. When using suitable heaters (available e.g. in specialist shops), keep a minimum distance of 1.2 m to tarp
material. Open fire or heaters with open flames such as patio heaters, umbrella heaters, gas heaters etc.
should not be used in any case.
6. The person setting up the tent is responsible for adequately securing it to ensure its safety.
Attach the side covers to the pipes (7, 8) using hooks (31). Reinforce the side frame by attaching
dismanteled
and packed up when it is wet. First, allow it to dry completely.
Remove the slight oil film from the pipes
Make sure, that the leg pipes are in vertical position,