Cascade 45C Kurulum Talimatları Kılavuzu - Sayfa 3

Fitness Ekipmanları Cascade 45C için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Cascade 45C 6 sayfaları. Load push and load push/pull

Sayfayı Yazdır

C. Installation

Center the lift truck behind the attachment.

Tilt the mast

forward. Engage the upper hook locating tab with the

closest upper carriage bar notch and raise the truck

carriage into position behind the attachment.

Lift the

attachment

2 in. (5cm) off the pallet.

NOTE:

The attachment

may not be perfectly centered on

the carriage bar when the locating tab is engaged

in the

upper carriage bar notch.

WARNING:

The upper mounting

hook must be properly engaged

with

the upper carriage bar. The locating

tab must be engaged

in the mating

notch on the upper carriage bar.

NOTE:

The lower hooks cannot be properly installed if

the locating tab is not engaged

in the carriage notch.

@ Engage the lower hooks with the truck lower carriage bar.

Bolt

On-Type- Install the hooks and capscrews.

Tighten the capscrews

finger tight. Tap the end of the

hooks with a hammer in the direction of the adjust

arrow for

maximum

engagement

with the carriage bar.

Tighten the capscrews

to a torque of 105-115 ft.-lbs.

(140-155 N.m).

Quick Change Type A- Turn

both hooks up and

reinstall the pin. The maximum allowable clearance

between the hooks and carriage bar is 18 in. (4mm) as

shown.

Quick Change Type B- Remove

the locking pins.

Slide the hooks up to engage with the carriage bar.

Install the locking pins through the upper holes.

CAUTION:

If the clearance

between the carriage

bar and the hooks exceeds 3/16 in. (6mm), the

guides (refer to Prior to Installation, step 1) should

be inverted and installed with the hole offset

downward

(5/8 in./16mm from bottom of guide to

hole center) to minimize the gap.

@ Measure the hydraulic hose length required to connect

the hoses to the hose terminal. Remove the hoses and

cut to length as required.

CAUTION:

Flush the hoses as follows to prevent damage to

the attachment

hydraulic components.

Connect the hoses to the truck hose terminal. Connect

the hoses together using a union fitting. Start the truck

and actuate the truck control valve in both directions for

about 30 seconds to carry any debris in the hoses to the

truck hydraulic tank and filter.

@ Remove the union fitting and connect the hoses to the

attachment fittings as shown.

BoItOnTypa

Lower carriage bar

(Right side shown)

Truck

Lower

lower

hook

(Left side shown)

Lower

Carriage

Bar