Cascade CMXErg+ Kullanıcı El Kitabı - Sayfa 6

Egzersiz Bisikleti Cascade CMXErg+ için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Cascade CMXErg+ 12 sayfaları.

ASSEMBLY INSTRUCTIONS

Follow these instructions to quickly setup your new CMXErg+ and you will be on the way to starting your new fitness

program. Failure to follow these simple instructions will void your warranty and could result in injury!

Your CMXErg+ will arrive in a single carton:

Contact the delivery carrier immediately if any damage to the carton is apparent.

Contact the Cascade Health and Fitness Customer Service Department at (+1) 425.402.4062 between 8:00a.m. -

5:00p.m., M-F, Pacific time to report any damages that have occurred during shipping.

Unpack shipping carton in the location where the CMXErg+ will be used. Cut the shipping straps, remove the

staples and slide off the top carton.

CONTENTS

1 pc - CMXERG+ body

1 pc - Left crank arm with grip

1 pc - Right crank arm with grip

2 pcs - AAA batteries

1 pc - Multi Tool

Find the left and right cranks and install them. The round yellow knobs will need to be

loosened, then pull them out while inserting the crank. When the crank is inserted to the

desired length release the yellow knob and make sure it pops back in place. To make sure

the crank is locked in place, try to move it. If it is secure then tighten the yellow knob by

rotating it clockwise.

The cranks can be installed to face in the same direction or they can be put 180 degrees

opposite of one another as shown in diagram.

Before using the CMXErg+ always make sure the pin of the knobs on each side are fully

engaged in the cranks and that each yellow knob is fully tightened.

Insert the 2 AAA batteries in the console by sliding open the back. Then slide the back onto the console.

Your CMXErg+ set up is now complete!