Cascade 6820937 Kurulum ve Kullanım Kılavuzu - Sayfa 4

Endüstriyel Ekipmanlar Cascade 6820937 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Cascade 6820937 6 sayfaları. Rotator shut-off – switch activated

Sayfayı Yazdır

Test Procedure

Perform by Qualified Personnel only.

Test the installation before putting the truck in service.

When the truck key is turned ON, the cab indicator green

light should be off.

Press the button and observe that the cab indicator green

light turns on.

With button released, attempt to rotate the attachment CW

and CCW. The attachment should not rotate. Then, with

button pressed, verify that the attachment will rotate in CW

and CCW directions.

Operation

WARNING: All operators must read this

section.

Before operation, inspect the switch, indicator,

valve, wiring and test operation daily.

Operators must have a thorough knowledge

and understanding of the safe operation of the

attachment and Rotator Shut-Off system.

The Rotator Shut-Off kit helps prevent accidental rotation and

requires a definitive action by the driver. The attachment is

allowed to rotate when the switch is activated and the green

light on.

• Press the switch button, then operate the truck ROTATE

control lever to rotate the load. When the green light is on,

the attachment will rotate normally.

• If the attachment will not rotate when the button is pressed,

set the load down, turn off the truck key and troubleshoot

the system. Follow Test Procedure before returning to

service.

CAUTION: The system does not prevent accidental

release or movement of a load. The cab indicator green

light does not indicate that the load has been lowered to its

optimal position or that it is ok to release a load.

WARNING: Residual risk exists to personnel in

the work area, operate only in compliance to

facility, state and federal standards.

For this accessory:

a) The Weighted Emission Sound Pressure Level (LpA) does not

exceed 70 dB(A).

b) The Value of Whole Body Vibration does not exceed 0,5 m/s^2.

c) The Value of Hand-Arm Vibration does not exceed 2,5 m/s^2.

Troubleshooting

Service only after reading this manual and by Qualified

Personnel only.

• Check all system fuses.

• Verify 12VDC at switch connector.

• Check switch function (N/O switch).

• Check 12VDC at solenoid when switch is pressed.

• Check for 12VDC at Indicator Light when switch is pressed.

Switch

Solenoid

Valve

Temporarily Disabling System

The Rotator Shut-Off can be disabled by performing the

following steps:

• Tag equipment as not operational. Do not operate when

system is disabled or known to malfunction.

• Disconnect the two hose ends to the normally-closed

solenoid valve and connect them together with a union.

• Remove the system power fuse in the cable harness to

disable indicator light.

The truck and attachment will now operate without the Rotator

Shut-Off feature. To enable, reverse the above procedure.

Solenoid Valve

Indicator

AC2293.eps

System Fuse

AC1978.eps