Danfoss 080Z3222 Kullanıcı Kılavuzu - Sayfa 12

Kontrolör Danfoss 080Z3222 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Danfoss 080Z3222 20 sayfaları. Three phase

Sayfayı Yazdır

User Guide | Optyma™ control AK-RC 113 three phase

12 | BC317523579312en-000101

Defrost type: with heater elements, cycle inversion

(hot gas) or with thermostatic resistance.

Warning: do not set d1=1 in this type of panel; see

Section 5.15.

dPo

Defrost at Power On

dSE

Smart defrost

dSt

Smart defrost Setpoint (if dSE=1)

The count of the time between defrosts is increased

only if the compressor is on and the evaporator

temperature is lower than dSt.

Display during defrost

dFd

Modbus Network address

Bdr

Modbus baudrate

Prt

Modbus parity check

Ald

Minimum and maximum temperature

signalling and alarm display delay

Minimum time between shutdown and subsequent

switching on of the compressor.

CAL

Cold room sensor value correction

CE1

Compressor ON operating time in the event of a

faulty ambient probe.

(emergency operation).

With CE1=0 the emergency operation in the

presence of error E0 remains disabled, the

compressor remains off and defrosts are inhibited to

preserve the residual cold.

Compressor OFF operating time in the

CE2

event of a faulty ambient probe.

doC

Compressor safety time for door switch:

when the door is opened the evaporator fans shut

down and the compressor will continue working for

time doC, after which it will shut down.

tdo

Compressor restart time after door opening. when

the door is opened and after tdo time, it's setted back

the normal functioning giving door open alarm (Ed)

If the door switch is closed and the light stays on for

a longer time than tdo light cell alarm is signaled

(E9). With tdo=0 the parameter is disabled.

Fst

FAN shutdown TEMPERATURE

The fans will stop if the temperature value read by

the evaporator sensor is higher than this value.

Fst differential

LSE

Minimum value attributable to setpoint.

HSE

Maximum value attributable to setpoint.

0 = element

1 = hot gas (see section 5.15)

2 = with thermostatic resistance

0 = disabled

1 = defrost at power-on

(if possible)

0 = disabled

1 = enabled

-30 – 30 °C

0 = current temperature

1 = room temperature at the

beginning of the defrost

2 = "DEF"

0 – 247

0 = 300 baud

1 = 600 baud

2 = 1200 baud

3 = 2400 baud

4 = 4800 baud

5 = 9600 baud

6 = 14400 baud

7 = 19200 baud

8 = 38400 baud

0 = none

1 = even

2 = odd

0 – 240 min

0 – 15 min

-10 – 10 °C

0 – 240 min

0 = disabled

5 – 240 min

0 – 5 min

0 – 240 min

0 = disabled

-45 – 99 °C

1 – 10 °C

-45 – (HSE-1) °C

(LSE+1) – 99 °C

1 °C

120 min

0 min

0 °C

0 min

5 min

0 min

99 °C

2 °C

-45 °C

99 °C