Abu Garcia Max Series Manuel - Sayfa 5

Kablolar ve konektörler Abu Garcia Max Series için çevrimiçi göz atın veya pdf Manuel indirin. Abu Garcia Max Series 7 sayfaları.

Abu Garcia Max Series Manuel
HOW TO FILL THE SPOOL WITH LINE
All Max™ low profile reels are designed for monofilament, braid and fluorocarbon lines. Personal preference and fishing conditions will determine line
selection. Begin by passing the line through the guide located on the front of the reel. Secure the line to the reel using the arbor knot. Control the filler spool by
inserting a pencil into the spool hub. While maintaining tension on the line with your fingers, wind the reel handle and continue to fill with line to approximately
1/16" (1.5 mm) below the top of the reel spool for best results (show picture). Do not overfill.
Some anglers prefer to add a monofilament backing to the reel spool before attaching braided line. This helps reduce line slip. Using the above instructions, fill
the spool with enough monofilament line to cover the spool. Tie the tag end of the monofilament backing to the braided line using a uni-to-uni knot, Albright
knot or equivalent. Continue to fill the spool with braid to approximately 1/16" (1.5 mm) inside the upper lip of the spool. Do not overfill.
how to tie the uni-to-uni knot in this video)
DRAG ADJUSTMENT
All Max™ low profile reels deliver smooth and reliable drag tension. Control the amount of drag by turning the adjustment star inside the reel handle. Rotate
the star clockwise (right) to increase drag or counterclockwise (left) to decrease drag. For best results the drag should be adjusted to approximately one-
third of the breaking test of the line being used. This can be accomplished by tying the line to a spring scale for precise adjustment. Make sure the reel is
first mounted on a rod and the line has been run though the rod guides before tying to the scale. The drag should always release before the line reaches its
breaking point. Factors such as line type, technique and fishing conditions may require adjustment to these recommendations. Any drag setting above half of
the line strength risks line breakage.
If a spring scale is unavailable, tie the line to a secure point. With the rod tip up (about a 45 degree vertical angle), apply pressure by turning the handle.
Gradually tighten the drag adjustment star by rotating it clockwise. When the line reaches its breaking point, loosen the adjustment star ¼ turn.
SPOOL TENSION KNOB
The spool tension knob controls how fast the spool spins when casting. It is located on the sideplate of the reel next to the handle. With the rod-reel-line-lure
properly assembled, place the tip of the thumb on the line to hold the spool. Depress the thumb bar with the pad of your thumb to disengage the gears. Allow
the lure to drop to the ground. If the lure does not fall when the thumb bar is depressed, turn the spool tension knob counterclockwise (left) to reduce tension
on the spool. If the lure falls to the ground and the spool continues to rotate, spool tension is too loose. Rotate the knob clockwise (right) to increase tension.
Additional casting brakes, if applicable, are designed for fine tune adjustment.
It is normal to experience backlashes when learning how to cast a low profile reel. In the event that you are just learning how to cast, tighten the spool tension
knob an extra ¼ to ½ a turn and slowly back it off as you learn to cast.
MAX FAMILY LP MANUAL
(CLICK HERE
to learn how to tie the arbor knot in this video)
(CLICK HERE
to learn
abugarcia.com