Dukane WMIC1 Hızlı Başlangıç Kılavuzu

Mikrofon sistemi Dukane WMIC1 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Dukane WMIC1 2 sayfaları. Wireless mic

Wireless Mic WMIC1

Connect the Receiver to the USB Power adapter by the USB to DC Power ca-

ble . Use the DC port (13 , see below ) on the Receiver.

Plug USB Power Adapter into a 115 VAC power outlet.

Turn Receiver power (12) to ON. The green LED will come on and continue to

slowly blink.

Turn the switch (11) to 20dB / MIC

Press the Vol+ and Vol- ( 2 and 7 ) to get the display (5) to read 15.

Press the CH+ and CH- (4 and 9 ) to set the channel. A good choice is a chan-

nel of 50 or above to reduce the potential of any WiFi interference. The display

(5) shows the channel.

Connect the 3.5 mm mini audio output port (6) with a 3.5 mm mini stereo cable

to the MIC input or audio input on a projector or a sound system. The audio out is

at line level.

Connections for a typical Dukane projector

Connect the audio cable to MIC port on the projector.

Go to the projector menu and set mic level High;

ADVANCED MENU / AUDIO/ MIC LEVEL / HIGH

Then set the MIC VOLUME to midrange , about 30;

ADVANCED MENU / AUDIO/ MIC VOLUME / Set midrange

For the projector to have the sound system operating when the lamp is off set the Standby

Mode to Normal ;

ADVANCED MENU / STANDBY MODE / NORMAL

Projector speakers ; If using the projector speakers be sure they are turned ON.

Also projector volume needs to be set at a suitable level.

Quick Start Guide

Pg 1 of 2

RECEIVER

Blank , closed port

Green LED—Status

Audio Output jack, 3.5 mm

Audio out-

Set switch to 20dB / MIC

Power switch ; set to ON

Power Input jack

WMIC1_Quick Start Guide Rev 01