Airwalk EdgePoint PRO Kurulum Kılavuzu - Sayfa 10

Kablosuz Erişim Noktası Airwalk EdgePoint PRO için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Airwalk EdgePoint PRO 19 sayfaları.
Ayrıca Airwalk EdgePoint PRO için: Referans Kılavuzu (15 sayfalar)

EdgePoint PRO Installation Guide
______________________________________________________________________________
Figure 3 - Multiple eFemto deployed within a Cluster Configuration

4.2.1 Network Requirements

To get the eFemto device operating in optimal conditions, a customer's IP network needs to
meet the following bandwidth and capacity requirements:
Service Usage
Type
Requirements
Maximum
5 Mbps
Capacity
Idle
20 Kbps
Voice Traffic Only 60 Kbps per call
Data Traffic Only 3 Mbps per device
(maximum)
If multiple devices are installed throughout a campus there will be an increase of IP
traffic on the LAN
LAN Installation Considerations:
The eFemto device supports standard RJ 45 LAN connection (100BASE-TX Ethernet
Switch/Router is recommended).
The eFemto device supports DHCP as well as static IP addressing. The device is
shipped from the factory with the DHCP IP addressing scheme.
The LAN needs to be able to access the customer's WAN network to allow the eFemto
to connect to the operator's network across the Internet.
Signaling and traffic for Soft Handoff between cluster members goes across the LAN
network.
WAN Installation Considerations:
Must Open UDP Ports 500 and 4500 for ISAKMP signaling between the eFemto and
the Security Gateway. Support for IPSec NAT-Traversal.
Intrusion Prevention Systems should be properly configured for the device and
Security Gateway communication if required.
Support for DSCP marked IP packets if possible on the customer's IP network.
AirWalk Proprietary and Confidential
 
Customer Premise
Bandwidth
29 voice calls and 32 active data users,
simultaneous
No active users
Maximum of 29 concurrent calls
Maximum of 32 simultaneous data sessions
Operator's Network
Capacity Description
Page 10 of 19
IPSec Tunnel for
each device
SeGW