3S Vision N1011 Bağlantı Şeması - Sayfa 2

Güvenlik Kamerası 3S Vision N1011 için çevrimiçi göz atın veya pdf Bağlantı Şeması indirin. 3S Vision N1011 2 sayfaları. Box network camera

Sayfayı Yazdır
1. Audio Out
2. MIC In
3. Wireless Antenna
4. POWER LED Indicator
5. RESET Button
6. LAN/POE Socket
7. DC POWER Inlet
8. BNC Connnector
Before connect this product, please make sure your PC has the LAN port available for connect to the network.
1
Connect lens as shown
Remove the cover of sensor and connect the lens by
screwing it into the camera clockwise.
* Lock the lens after lens connected by keeping screwing.
It will be idle running if the lens is locked.
NOTE:
1. Adjusting lens mount
Please use a C-CS adapter if your
lens is using C Mount.
2. Lens adjustment
Use the hexagonal wrench to release
the lens ring and adjust the lens,
if there is any unfitted condition
occurred after the lens is connected.
RMIM-01G05031 Ver:20
BOX Network Camera
9. Micro SD Card Slot
10. IRIS Jack
11. Extension I/O Terminal Block
2
Making Connections
The product can operate on DC12V, DC12V/PoE
based on the model you have.The power inlet of the
Network Camera is non-polarized, it can automatically
determine the type of the incoming current.
•Wireless Antenna
•HUB
•PC
•Power
* Function of Wireless Antenna, TV Out and Auto IRIS are
available only for the models which are supported.
Making Connec ons
DESCRIPTION
1. Audio Out
2. MIC In
3. Wireless Antenna
4. Power LED Indicator
5. Reset Button
6. LAN/POE Socket
7. DC Power Inlet
8. BNC Connector
9. Micro SD Card Slot
10. IRIS Jack
11. Extension I/O Terminal Block
* Some function will be different depending on the model.
•MIC
•Speak
•Speaker
•
•IRIS Jack
Connect to speaker out.
Connect to microphone in.
Connection to wireless antenna here.
The led indicator will light in red when the power on.
Reset to factory setting.
Connect to 10/100 RJ45 network / PoE here.
Connect to power here.
Connect the monitor to the BNC adapter.
Insert the micro SD card here.
Connect the lens cable plug to the IRIS Jack.
TTL alarm and RS485 connection.
2
Extension I/O Terminal Block
In addition to the motion detection executed by the
internal software application, ths product provides an
extension I/O terminal block which is used to connect
external infrared detectors, beepers and
smoke detectors.
9
8 7 6 5 4 3 2 1
PIN
Alarm input
Alarm output
● High dB alarm
Pin
Function
Pin
1.
Alarm In_A
2.
3.
Alarm Out_COM
4.
5.
Alarm Out_NO
6.
7.
RS485-
8.
9.
GND
● Infrared Inductor
● Alarm
Function
Alarm In_K
Alarm Out_NC
RS485+
DC12V Out