Danfoss iC7 Series Kurulum Kılavuzu - Sayfa 13

DC Sürücüler Danfoss iC7 Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Danfoss iC7 Series 14 sayfaları. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Ayrıca Danfoss iC7 Series için: Kurulum Kılavuzu (8 sayfalar), Kurulum Kılavuzu (8 sayfalar), Kurulum Kılavuzu (6 sayfalar), Kurulum Kılavuzu (16 sayfalar), Kurulum Kılavuzu (8 sayfalar), Kurulum Kılavuzu (8 sayfalar), Kurulum Kılavuzu (10 sayfalar), Kurulum Kılavuzu (16 sayfalar), Kurulum Kılavuzu (16 sayfalar), Kurulum Kılavuzu (6 sayfalar), Kurulum Kılavuzu (6 sayfalar), Kurulum Kılavuzu (16 sayfalar), Kurulum Kılavuzu (18 sayfalar)

In-bottom/Out-top Cooling Kit for FA11-FA12

Installation Guide

2.10 Attaching the Bottom Duct to the Duct Support Bracket

After the frequency converter is installed on the mounting plate, attach the telescopic bottom duct to the duct support bracket

using the following steps.

Procedure

Extend the telescopic bottom duct upward until the upper flange of the duct is positioned against the duct support brack-

et.

Secure the duct to the bracket with 4 M5x18 screws (T25).

Torque fasteners to 2.3 Nm (20 in-lb).

2.11 Attaching the Top Duct to the Top Plate

After the frequency converter is installed on the mounting plate, attach the top duct to the cabinet top plate using the following

steps.

Procedure

Extend the telescopic top duct upward until the upper flange of the duct is positioned against the underside of the cabinet

top plate.

Secure the duct to the top plate with 6 M5 hex nuts (T25).

Torque fasteners to 2.3 Nm (20 in-lb).

2.12 Installing the Backplate

To attach the backplate of the Rittal cabinet, use the following steps.

Procedure

Position the backplate on the back rails of the cabinet behind the mounting plate.

Secure the backplate to the rails behind the mounting plate using the existing fasteners.

Installation

AN361429548582en-000201 / 136R0255 | 13