Danfoss iC7 Series Kurulum Kılavuzu - Sayfa 5

DC Sürücüler Danfoss iC7 Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Danfoss iC7 Series 16 sayfaları. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Ayrıca Danfoss iC7 Series için: Kurulum Kılavuzu (8 sayfalar), Kurulum Kılavuzu (8 sayfalar), Kurulum Kılavuzu (6 sayfalar), Kurulum Kılavuzu (14 sayfalar), Kurulum Kılavuzu (16 sayfalar), Kurulum Kılavuzu (8 sayfalar), Kurulum Kılavuzu (8 sayfalar), Kurulum Kılavuzu (10 sayfalar), Kurulum Kılavuzu (16 sayfalar), Kurulum Kılavuzu (16 sayfalar), Kurulum Kılavuzu (6 sayfalar), Kurulum Kılavuzu (6 sayfalar), Kurulum Kılavuzu (18 sayfalar)

Sayfayı Yazdır
Danfoss iC7 Series Kurulum Kılavuzu
In-back/Out-back Cooling Kit for FA09-FA10
Installation Guide
2.3 Preparing the Mounting Plate
To create mounting holes and vent holes in the mounting plate, use the following steps. Refer to
converters, and
Illustration 4
Procedure
1.
Drill 4 mounting holes in the mounting plate using the dimensions in the FA09 or FA10 template.
The holes must match the holes in the frequency converter.
2.
Insert 4 M10 pem studs (not supplied) in the mounting holes.
3.
Cut out the 2 vent openings in the mounting plate using the dimensions in the FA09 or FA10 template.
The openings must match the upper and lower duct openings.
2x Ø 8 (0.3)
Mounting Holes
130 (5.1)
844 (33.2)
699 (27.5)
140 (5.5)
4x Ø 5 (0.2)
Illustration 3: FA09 Mounting Plate Template for In-back/Out-back Cooling
Danfoss A/S © 2022.03
for FA10 frequency converters.
214 (8.4)
180 (7.1)
7 (0.3)
78 (3.1)
7 (0.3)
122 (4.8)
200 (7.9)
214 (8.4)
228 (9.0)
122 (4.8)
68 (2.7)
10 (0.4)
78 (3.1)
6x Ø 8 (0.3)
2x Ø 8 (0.3)
Mounting Holes
177 (7.0)
Installation
Illustration 3
for FA09 frequency
110 (4.3)
AN371942471353en-000101 / 136R0248 | 5