CashConcepts CCE 415 P Manuel - Sayfa 17

Para Sayma Makineleri & Bozuk Para Ayırıcılar CashConcepts CCE 415 P için çevrimiçi göz atın veya pdf Manuel indirin. CashConcepts CCE 415 P 18 sayfaları.

Sayfayı Yazdır

CCE - Cash Concepts Europe GmbH

Kemptener Straße 99 – D-88131 Lindau / Germany

Tel.: +49 (0)8382 – 943 15 – 0 / Fax: +49 (0)8382 – 943 15 – 20

Email: [email protected] / Web: www.cce.gmbh

Error Message

IR sensor error

Metal sensor error

Rotate speed sensor error

Please remove the gasket

Please replace the brush

Coins were not transported or jammed

Replacing the fuse

The CCE 415 is protected by a fuse which can be exchanged by you without big expenditure in case of need.

Please switch off the machine before the change of the fuse and pull the net plug from the device. There is mortal danger on

the basis of electric shocks by no observance.

Draw off the cover of the fuse and exchange it with an equivalent one. The fastener of the fuse must be pressed after the change

again firmly.

Troubleshooting

Please clean the sensors of the machine, as described in the

corresponding chapter of this manual.

Please contact your service partner, the machine must be

repaired by a technician.

Please refer to the chapter Fault Management and Maintenance

in this manual, there are instructions for removing this message.

The Transport brush is worn and must be replaced, please

contact your service partner or CashConcepts Europe GmbH.

Remove the safety pin and increase the pressure of the transport

brush spin direction. "-" And fasten the brush then again with the

safety pin