Dunbrik FireFlexmaster Manuel - Sayfa 5

Şömine Aksesuarları Dunbrik FireFlexmaster için çevrimiçi göz atın veya pdf Manuel indirin. Dunbrik FireFlexmaster 8 sayfaları. Multi fuel flexible chimney liner

Sayfayı Yazdır

FireFlexmaster

PREPARATION

Good working practices and statutory health and safety considerations should be followed. The

installation of

FireFlexmaster

Safe working platforms or other means of access should be arranged to avoid accidents. Wear

protective gloves, goggles and dust-masks, particularly when handling dusty or sooty materials.

There is a danger of cuts and abrasions from the liner and metal fittings.

FireFlexmaster

can be used with UK fuels

well as wood and wood products, providing it is suitably cured. The product is not suitable for

biomass boilers or stoves.

SIZE OF LINING

The following is a general guide for flue sizing but referral should be made to Building

Regulations ADJ Clause 2.4 and Table 2.

Solid-fuel stoves, room heaters, boilers and cookers:

Minimum 6" (150mm) diameter, 7" – 8" (175mm – 200mm) for larger or multi-fuel appliances.

Other appliances:

Consult the appliance manufacturer. Unless the appliance manufacturer recommends

otherwise, the diameter of the liner should not be smaller than the appliance outlet.

PREPARING THE CHIMNEY

Check that the appliance and chimney arrangements are satisfactory and that the walls of the

chimney are at least 100mm thick solid masonry; ensure that the chimney is structurally sound.

Clean the chimney using a brush and rods, your chimney sweep should be able to determine

the length of the chimney, you will need to know this to order the correct length of

FireFlexmaster

flue

FireFlexmaster

chimney liner is supplied in one continuous length.

the

FireFlexmaster

chimney liner

pots, cappings, damper plates or any other obstructions, which might effect installation of the

liner. If there are severe bends or obstructions in the length of the flue, the chimney wall will

require opening to ensure proper access and installation. The openings must be repaired using

the appropriate materials and workmanship after installation.

There are two methods of installation at the top of the stack that we suggest;

Without chimney pot or

With chimney pot.

Installation

For Gas, Oil, Wood and Solid Fuel

chimney lining is a two person job.

liner.

cannot be joined together.

For Gas, Oil, Wood and Solid Fuel

such as standard fuel oil, gas, 'clean burn' coal,

Remove any terminals, chimney

Tel: 01924 373694

Fax: 01924 383459

Email:

Web:

It is better to over order as

[email protected]