Duncan Enviro DD30 Kullanıcı El Kitabı - Sayfa 11
Traktör Aksesuarları Duncan Enviro DD30 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Duncan Enviro DD30 17 sayfaları. Smart ag electric drive operation
Sayfayı Yazdır'Enviro DD30'
Seed Calibration
With the drill set up for calibration and the display configured
for the chosen product we are now ready to calibrate.
1
Navigate to the Bin/Tank screen if not there already.
2
Touch Product to get to the Product screen as shown.
3
Touch Calibrate
4
Touch Calibration Rate. Change this to the same rate as
the Application Rate chosen previously. This means that
the calibration speed matches the actual sowing speed to
improve accuracy. Touch the tick to accept. Tick again to
get to the Bin/Tank Calibration screen.
5
From the Bin/Tank calibration sceen touch on Start
Calibration. Touch Calibration Amount.
6
Enter a value for the amount to calibrate. 2kg is a
suggested value. If calibrating small seeds a smaller value
may be needed to save waiting too long for the calibration
to finish. Tick to acccept.
7
Check that the caibration trays are in place and the clear
plastic seed directors are folded down. Press 'play' to start
the calibration.
8
When the calibration has stopped running, weigh the seed
collected. Weigh to an accuracy of 1 gram (0.001kg).
9
Touch Measured Amount and enter the value you
weighed. Touch tick. It may not be the same as the
amount you asked for especially on a new product.
9
Calibration
Pt. No. 67453
Issue 0321