Danfoss BasicPlus2 WT-D Kurulum Kılavuzu - Sayfa 2

Termostat Danfoss BasicPlus2 WT-D için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Danfoss BasicPlus2 WT-D 8 sayfaları. Room thermostats

Installation Guide

1. Installation Steps

User Guide can be downloaded from: heating.danfoss.com.

1. Installation must be done by an authorised

electrician.

2. The room thermostat should be installed at approx.

1.5 m above floor and where the effects of sunlight,

draught or other heat sources (eg. TV's) are avoided,

see fig. 1.

3. First of all, carefully remove the cover, see fig. 2.

4. Connect the wire before mounting the back plate to

the wall box using the enclosed screws. Then mount

the cover to the back plate, see fig 3.

2. Wiring

Dimensions, see fig. 4. Wiring diagram, see fig. 5 (S1, S2:

floor sensor terminals).

WT-D/P is often used with Danfoss TWA actuator.

Depending on the conditions of power location and

actuator type (NC or NO), the wiring between room

thermostat and actuator is different.

Follow the illustrations to complete the wiring:

1. When power supply location is close to room

thermostat:

• Connect to actuator TWA 230 V NC type,see fig. 6.

• Connect to actuator TWA 230 V NO type, see fig. 7.

BasicPlus

WT-D & WT-P

VICUJ212

Danfoss Heating Solutions