3T-Components 3T-MOTORS 3T45-10E Kurulum ve Kullanım Talimatları Kılavuzu - Sayfa 9

Motor 3T-Components 3T-MOTORS 3T45-10E için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları Kılavuzu indirin. 3T-Components 3T-MOTORS 3T45-10E 12 sayfaları. Shutter motors with obstacle detection and electronic limit switches

Sayfayı Yazdır

3T-Components 3T-MOTORS 3T45-10E Kurulum ve Kullanım Talimatları Kılavuzu

INSTALLATION INSTRUCTIONS

Setting the end positions:

1. Check direction of rotation!

When you press the Up button, the roller shutter must move upwards! If this is not the case, exchange the black and brown wires.

Please program each motor individually!

Automatic mode:

Fixed shaft connectors and stoppers

or angle end rail are

absolutely necessary!

2. Initialization

The engine is delivered from the factory

in Automatic mode:

Allow the roller shutter to move up and down completely once.

> The motor detects the end positions and stops automatically.

Note:

After three further cycles (3x completely up and down), the roller shutter no

longer moves against the end stops, but stops automatically beforehand.

Every 60 cycles, the drive independently checks and corrects the end

positions in fully automatic mode.

Function overview Adjustment cable ESKS:

LED On/Off

Buttons & Function

Up button: Controls the motor upward

Down button: Controls the motor downward

SET button: Select operating mode, initialization, save end position

LED On/Off lights up permanently: Mains operating mode

LED On/Off flashes: Programming mode Electronic motors

Up button

Down button

SET button

Manual mode:

Suspension springs and no stoppers.

2. Connecting the ESKS plug

> LED On/Off lights up permanently.

3. Press Down button + SET button simultaneously

> LED On/Off flashes: The ESKS is in the

Programming mode for electronic motors.

4. Initialization

Press the SET button until the shutter is

has briefly moved up and down.

5. Setting the lower end position

Move the curtain to the desired lower end

point. Press the SET button, until the curtain

has moved up and down briefly.

6. Setting the upper end position

Move the curtain to the desired upper end

point. Press the SET button until the curtain

has moved up and down 2x briefly.

Now the end positions are stored.

Reset to factory setting:

Press the SET key for 12 sec until the curtain

moves up and down 3 times briefly.

Now the drive is in the delivery

state and can be reprogrammed!

3T-MOTORS Tubular motors | Installation instructions