3TECH TC-70 Kullanıcı Kılavuzu - Sayfa 3

Isıtıcı 3TECH TC-70 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. 3TECH TC-70 10 sayfaları. Heater for composites and anaesthesia cartridges

Sayfayı Yazdır
3TECH TC-70 Kullanıcı Kılavuzu
REMARQUE
Introduire la résine composite avec son capuchon, pour empêcher le matériau de fuir et de pénétrer à
l'intérieur du corps chau ant.
4. Nettoyage et désinfection
Toutes les pièces peuvent être nettoyées avec des lingettes sans alcool.
Ne pas immerger les pièces dans un liquide
Ne pas stériliser par autoclave
5. Paramètres techniques
– Puissance : 24W
– Réglage de la température à 40 ± 1°C, 50 ± 1°C et 70 ± 1°C
Adaptateur secteur
– Entrée : 100-240V AC 50/60Hz 0.8A Max
– Sortie : 12V CC 2A

6. Garantie

Toutes les pièces de cet équipement sont garanties 1 an. Les dégâts d'origine humaine ne sont pas
couverts par la garantie.
Renvoyez l'appareil à votre distributeur pour réparation en cas de problème.
Ne démontez pas l'équipement en vue d'un entretien. Si vous le démontez et le réparez vous-même,
vous ne serez plus couvert pour la période de garantie gratuite.
4
HEATER TC-70

1. Product Description

HEATER TC-70 is designed to heat composite resin materials to improve fl uidity performance and
adaptation to dental cavities. It can also be used to heat the anaesthesia carpels to inject the anaesthetic
product without pain.
HEATER TC-70 uses a precision circuit system to control its heating module, maintaining a temperature
tolerance of ±1°C. Depending on the material and your personal choice, the temperature can be set at
40°C, 50°C or 70°C.
2. HEATER TC-70 composition
1. Heating body
2. Adapter
3. Temperature indicator
4. On/O button
5. Temperature selection button
6. Power DC jack
3. Operating
1. Insert the DC plug of the power adapter into the DC socket of the heating body. Then plug the power
adapter into an electrical outlet. At this time, three temperature indicators are on at the same time
(standby heating).
2. Place the heated body on a fl at table.
3. Press the button on/o to turn on the heated body. Press the button again to turn o the heating
body.
The default temperature for heating the main body is 40°C.
When the heating body is o , three temperature indicators are on at the same time.
4. Press the temperature selection button to select the temperature you need.
Please consult the detailed temperature list:
Temperature
Indicator light color
40°C
Blue
Blue LED shining
50°C
Green
Green LED shining
70°C
Red
Red LED shining
• 40°C for composites and anaesthesia cartridges
• 50°C for composites
• 70°C for composites
When indicator light changes from blinking to steady light that indicates that the temperature has
reached the preset temperature.
5. Insert the composite resin (syringe or capsule) or anesthetic carpule into the hole in the heating body.
NOTE
Insert the composite resin with its cap to prevent the material from leaking inside the heating body.
en
Heating
Reach preset temperature
Blue LED is always on
Green LED is always on
Red LED is always on
5