Danfoss ECL Comfort 210 Kullanım Kılavuzu - Sayfa 6

Kontrol Ünitesi Danfoss ECL Comfort 210 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Danfoss ECL Comfort 210 16 sayfaları. Extended heat cut-out
Ayrıca Danfoss ECL Comfort 210 için: Kullanıcı Kılavuzu (12 sayfalar), Kullanıcı Kılavuzu (12 sayfalar), Kullanıcı Kılavuzu (6 sayfalar), Kurulum Kılavuzu (4 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kullanım Kılavuzu (10 sayfalar), Kurulum Kılavuzu (7 sayfalar), Kurulum Kılavuzu (16 sayfalar), Kurulum Kılavuzu (16 sayfalar), Kurulum Kılavuzu (16 sayfalar), Kurulum Kılavuzu (16 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (16 sayfalar), Montaj Kılavuzu (16 sayfalar)

Sayfayı Yazdır
Danfoss ECL Comfort 210 Kullanım Kılavuzu
ECL Comfort 210 / 296 / 310, Floor (Screed) Drying Program
When the floor drying process is finished, a data log can be read
from the ECL Comfort controller by means of the "ECL Tool". The
data log can be used for documenting the process.
The favorite display with temperature information of the heating
circuit(s) can, as an example, look like this:
Floor drying process not active:
Floor drying process active:
The progress bar is filled up from left side, according to time
elapsed since process start. The elapsed time and total process
time is also indicated in hours.
Return temperature related indications are not present, as the
return temperature limitation is cancelled during the floor drying
process.
Floor drying process being active can also be seen:
Circuit x > MENU > Influence overview > Des. flow T:
Before start of the floor drying process:
•
The control parameters must be set correctly (Circuit x > MENU
> Settings > Control parameters). See the Operating Guide for
the application in question.
•
The Time & Date must be set correctly (Common controller
> MENU > Time & Date). See the Operating Guide for the
application in question. The Time & Date settings are used in
the log facilities.
6 | © Danfoss | 2017.08
The mode selector of the ECL Comfort controller must not be in
Manual mode when the floor drying process is in progress.
VI.JM.P2.02