3W 157xi TS Manuel - Sayfa 12
Motor 3W 157xi TS için çevrimiçi göz atın veya pdf Manuel indirin. 3W 157xi TS 20 sayfaları.
Sayfayı Yazdır
•
There must be a minimum 4" separation between anything attached to the receiver and
all things related to the ignition (i.e., the ignition itself, and its wires, battery, and switch)
•
Use a plastic spiral sheath to protect the ignition cables
•
Never remove the sparkplug cap by using a mechanical aid like pliers. Only remove the
cap by hand using a twist/pull movement.
•
The spark plug cap must be firmly seated to the sparkplug. If the spark plug cap is not firmly
seated there is a very good possibility that you will experience radio interference.
•
Use only ignition on/off switches recommended by 3W
•
6 volts is required for the ignition.
•
Do not skimp on your throttle servo. A high quality throttle servo is recommended for reliable
and accurate operation of the carburetor.
•
Never fill the fuel tank via the carburetor fuel line
•
Use the same I.D. for tank ventilation and the carburetor fuel line
•
Use small plastic cable ties on all fuel line to fitting connections.
•
We recommend cutting the fuel line in the fuel tank in half. And, then joining them back
together with a brass tube. The brass tube prevents a folding of the fuel line with could cut
the fuel supply for the engine (see tank photo).
•
The use of soldered on DUBRO barbs on the ends of the brass tubing is highly recommended.
Again, always secure the fuel line with small plastic cable ties.
Warning!
Failing to read and follow all of the instructions in this manual can lead to unsafe conditions and
damaged equipment. Here are some examples:
•
Unbalanced propellers can damage the engine's ball bearings, needle bearings, even
3W 157xi B2 / TS / CS Engine Manual
more infos: www.3w-modellmotoren.de