3W 3W-55Xi Kullanım Kılavuzu - Sayfa 8

Motor 3W 3W-55Xi için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. 3W 3W-55Xi 20 sayfaları.

Ignition

Consideration needs to be given to the placement of the electronic ignition module. Avoid placing

the module in the path of hot air. Important: If the electronic ignition overheats it will

malfunction (e.g., backfiring or shutting down).

Ignition details:

•

The red cable is positive (+)

•

The ignition timing has been set at our factory

•

When fitting a new ignition it is important to achieve the correct coordination of the sensor(s)

to the magnets

Canister mufflers

To prevent damage to the header(s) a flexible support bracket is required to mount the canister(s).

The location for this bracket should be at the canister's center of gravity. 3W canisters have a

reinforcement ring at this location.

example image

We suggest creating two compartments in the front section of the fuselage by installing a horizontal

tray. Fuel tanks, batteries, and other equipment can be mounted on top of this tray; the canister(s)

being installed below it. Close off the lower compartment at its rear with an angled former. Locate

this former 1" behind the back of the canister(s). Next cut a hole in the bottom of the fuselage just

under the rear of the canister(s). In this way the air coming from the front of the model can flow

over the canister(s) and then be deflected by the angled former so as to exit through the hole in

the fuselage. Do not forget to reinforce around this hole.

Operation manual

Refer to our special ignition description for further information

3W Modellmotoren GmbH, Hasswiesenstrasse 22, 63322 Rödermark