3W 684i B4 Manuel - Sayfa 13

Motor 3W 684i B4 için çevrimiçi göz atın veya pdf Manuel indirin. 3W 684i B4 18 sayfaları.

•

Use a rubber stick to start the engine. Never use your hand or fingers!

•

Insure that your receiver batteries are charged and your receiver is on

•

Insure that your ignition battery(s) are charged

•

Insure that your transmitter is on, and that your throttle is set to low

•

Insure that your plane is properly and safely anchored (use one, two, or more people if

necessary)

•

Close the choke(s)

•

Switch on the ignition

•

Flip the propeller until the engine "pops" (starts and stops quickly)

•

Wait for the propeller to stop spinning, turn off the ignition, and open the choke(s)

•

Switch the ignition back on

•

Flip the propeller again until the engine starts

•

Warm-up the engine for at least 20 seconds

•

Due to the high power and torque of the engine(s) it is not recommended to open the throttle

abruptly

Precision tuning of the carburetor

The use of a tachometer is highly recommended. And, again, never adjust the needles while the

engine is running!

1. Using the tachometer tune the engine for maximum power with the high needle (H).

2. Again using the tachometer; richen the high needle (H) until the motor runs 100-200 RPM

less than the maximum RPM. Now you are tuned slightly rich on the high needle (H).

3. Let the engine run at idle for one minute. Check to see that the idle RPM remains constant.

4. If the idle RPM drops until the engine stops; the low needle (L) is too rich. Lean the low

needle (L) until a constant idle RPM is achieved.

5. Check the transition with a quick throttle advance. The engine should not sound strained

at any time. It should sound like it is making quick steady power; without any hesitation.

6. An optimally tuned engine will feel a bit rich after a cold start. It will start to run right after

it has warmed up for approximately one minute.

684i B4 / TS / QS Engine Manual

more infos: www.3w-modellmotoren.com