Dunlop Billy Duffy Cry baby BD95 Kurulum Talimatları - Sayfa 2
Müzik Pedalı Dunlop Billy Duffy Cry baby BD95 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Dunlop Billy Duffy Cry baby BD95 2 sayfaları.
Sayfayı Yazdır
BD95
BILLY DUFFY CRY BABY
POWER
CONTROLS
The Billy Duffy Cry Baby Wah can
1. MODE kickswitch toggles between 95Q
be powered by one 9-volt battery
mode (indicated by blue LEDs) and
(accessed via the bottom of the pedal),
Vintage mode (indicated by red LEDs)
a 9-volt AC adapter such as the Dunlop
2. VOLUME control sets 95Q mode's
ECB003/ECB003EU, or the DC Brick
™
output level
and Iso-Brick
™
power supplies.
3. Q control adjusts width of 95Q
CONTROL DIAGRAMS
mode's bandpass
4. AUTO-RETURN DELAY control
(internal) sets how long effect rings
out after being disengaged
•
•
5. BLUE trimpot (internal) sets toe-down
LED
LED
range of 95Q mode
MODE switch toggles between
VOLUME control boosts
95Q & Vintage modes
6. RED trimpot (internal) sets toe-down
gain up to +15dB
Q control adjusts wah
range of Vintage mode
frequency width
RED
BLUE
AUTO-RETURN
DELAY
WAH
®
SETUP INSTRUCTIONS
• Run an instrument cable from your
guitar to the BD95's INSTRUMENT
jack and another instrument cable from
the BD95's AMPLIFIER jack to your
amplifier's input.
• To engage the effect, simply push the
toe of the pedal down with your foot.
To disengage, remove your foot from
the pedal.
• Use MODE kickswitch to toggle between
95Q mode, indicated by blue LEDs on
either side of pedal, and Vintage mode,
indicated by red LEDs.
• Rotate internal AUTO-RETURN DELAY
control clockwise to increase length of
effect ring out or counterclockwise to
decrease it.
• Rotate the VOLUME control clockwise to
increase volume of effect in 95Q mode
or counterclockwise to decrease it.
Note: This control is inactive in
Vintage mode.
SPECIFICATIONS
• Rotate the Q control clockwise to
Impedance
narrow 95Q mode's bandpass and
Input
Output
emphasize higher end harmonics or
Noise Floor
counterclockwise for a wider bandpass
Heel Down
that emphasizes lower end harmonics.
Toe Down
Note: This control is inactive in
Center Frequency f c Range*
Vintage mode.
95Q Mode
• Rotate internal BLUE trimpot clockwise
for a brighter toe-down response or
Vintage Mode
counterclockwise for a warmer toe-down
response. Note: This control is inactive
Max Gain at f c
in Vintage mode.
Boost
• Rotate internal RED trimpot clockwise
Bypass
for a brighter toe-down response or
Current Draw
Power Supply
counterclockwise for a warmer toe-down
response. Note: This control is inactive
*Center Frequency f c Range specifications are with the RED
and BLUE potentiometers fully clockwise.
in 95Q mode.
• Rock your foot back and forth on the
pedal to hear the vocal, expressive tones
that the Cry Baby Wah is famous for.
800 kΩ
< 1 kΩ
< -98 dBV
< -90 dBV
410 to 2,000 Hz
+20/-10%
450 to 2,200 Hz
+17/-10%
17 dB
0.1 to 15 dB
Buffered
8 mA
DC 9 volts
DUNLOP MANUFACTURING, INC.
P.O. BOX 846 BENICIA, CA 94510 U.S.A.
TEL: 1-707-745-2722 FAX: 1-707-745-2658