Airwell AW-WHPMA06-91 Kurulum ve Ayarlama - Sayfa 5

Klima Airwell AW-WHPMA06-91 için çevrimiçi göz atın veya pdf Kurulum ve Ayarlama indirin. Airwell AW-WHPMA06-91 15 sayfaları.

Below shows a basic wiring schematic for use with the previous hydralic schematic, for the Airwell monobloc Heat

pump. Using a Third party room stat for switching on and off the heating demand.

Each terminal supplies a maximum of 0.2amp if the item connected draws more than 0.2amp a relay and a external

power supply should be used.

Power Supply Via

Switched Fuse Spur

The Domestic Hot water sensor is connected directly to the PCB on plug CN13. There is a flying lead with a plug on for

connecting this, this is located at the right-hand side of the unit. As in the

picture to the right-hand side.

The Domestic Hot water sensor is supplied with a 10m Cable, this cable

can be extended to a maximum of 20m. This should not be shortened.

W: www.aukdistribution.com

Control Wiring

Post Buffer

Pump

Power Supply Via Switched Fuse Spur*

*Pumps with a drawing less that 0.2A can be connected

directly to PCB

*Alternatively, the Immersion can be feed

Via a 3

Party time Clock Local to the

heater

T: 0191 516 6553