Danfoss VLT AutomationDrive FC 301 Kurulum Kılavuzu - Sayfa 7

Medya Dönüştürücü Danfoss VLT AutomationDrive FC 301 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Danfoss VLT AutomationDrive FC 301 16 sayfaları. 24 v dc supply
Ayrıca Danfoss VLT AutomationDrive FC 301 için: Kurulum Kılavuzu (20 sayfalar), Kurulum Talimatları Kılavuzu (6 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Talimatları Kılavuzu (8 sayfalar), Kurulum Kılavuzu (6 sayfalar), Kurulum Kılavuzu (16 sayfalar), Kurulum Kılavuzu (8 sayfalar), Kurulum Talimatları Kılavuzu (6 sayfalar)

Installation Guide | VLT® Programmable I/O MCB 115

2.3 Safety Precautions

UNINTENDED START

When the drive is connected to the AC mains, DC supply, or load sharing, the motor may start at any time, causing risk of death,

serious injury, and equipment or property damage. The motor may start by activation of an external switch, a fieldbus

command, an input reference signal from the LCP or LOP, via remote operation using MCT 10 Set-up software, or after a cleared

fault condition.

Press [Off] on the LCP before programming parameters.

Disconnect the drive from the mains whenever personal safety considerations make it necessary to avoid unintended

motor start.

Check that the drive, motor, and any driven equipment are in operational readiness.

LACK OF SAFETY AWARENESS

This document gives important information on how to prevent injury and damage to the equipment or the system. Ignoring

them can lead to death, serious injury, or severe damage to the equipment.

Make sure to fully understand the dangers and safety measures incurred in the application.

W A R N I N G

AN295938195323en-000101 / 130R0655| 7

Safety