Dunster House H4-1818ASH Kurulum Kılavuzu - Sayfa 13

Bahçe Evleri Dunster House H4-1818ASH için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dunster House H4-1818ASH 15 sayfaları. Adam i shed - 1.8m x 1.8m (6ft x 6ft)

Sayfayı Yazdır

STEP 12: WIND BRACE

Items:

ST-PT3535960 (Front+Rear)

ST-PT35351730 (Side)

28x 35mm SCREW

Principle of wind braces installation

Front view

Side view

Side wind brace

Front wind brace

STEP 13: FELT

Items:

Felt

360x 10mm CLOUT NAIL

Principle of felt installation

Felt layer 2

80mm

Assembly Steps

Pre-drill parts before fixing with screws

12a) Position the wind braces as shown in the diagram below. Make sure that they

are flush with edge of the roof board.

12b) Fix each wind brace by using 35mm screws. Use 4 screws for each front and

rear wind brace. Use 6 screws per each wind brace for the side. Refer to the image

below for more information.

35mm SCREW

Front wind brace

35mm SCREW

Rear wind brace

Pre-drill parts before fixing with screws

13a) Place the Felt layer 1 and 2 as is shown in the diagram below. Keep an

overhang of 80mm on each side. Fix felt onto roof board and then fix

overlaps onto wind braces with the 10mm clout nails.

13b) Position the Felt layer 3 as is shown in the diagram below. This layer

needs to overlap layers 1 and 2 by 200mm. The Felt layer 3 might require

horizontal cut, if your overlap is too long. Fix the Felt layer 3 into felt layers

1 and 2 and then fix overlaps onto wind braces. Use 10mm clout nail for all

fixings.

80mm

10mm CLOUT NAIL

80mm

Position of wind braces

FRONT

Felt layer 1

Felt layer 3

80mm

Felt

Attaching of overlap

(Front view)

10mm COUT NAIL

(Distance between

nails approx. 70mm)

10mm CLOUT NAIL

200mm

Felt Layer 1

80mm

Page 13