AddLife ROPOX FlexiPlus Kullanıcı Kılavuzu - Sayfa 17

Güvenlik Ekipmanları AddLife ROPOX FlexiPlus için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AddLife ROPOX FlexiPlus 17 sayfaları.

Performance test

It's important to test the functions of the frame, as well as the double safety before putting it into use. It's

important to follow up on these tests once a year, to make sure screws and cables are mounted correctly.

The procedure starts with a control:

1. Control the mounting instructions for FlexiPlus and the double safety to make sure it's done

correctly.

2. Control that screws are tightened.

3. Control that cables are pressed in fully.

4. Ensure that no obstacles are obstructing the frame from moving freely within its full range of motion.

The procedure continues with a test of the functions:

5. Test full stroke (height adjustment) on each frame – one drive to the top, one drive to the bottom.

6. Test each safety strip by itself – drive the first frame downwards, then press on the safety strip. The

frame should drive a few cm back. Do the same test for the other frame.

7. Test the connection between the safety strips – drive the first frame downwards, then press on the

other frame's safety strip. The driven frame should drive a few cm back.

8. Repeat step 7, but driving upwards – drive the first frame upwards, then press on the other frame's

safety strip. The driven frame should drive a few cm back.

The frame cannot be height adjusted

The frame only goes down

Frame is uneven

TF 200.0055 / Rev 2

Check all cables and plugs for loose connections

If a safety strip has been fitted:

Check that the safety strip has not been activated

Check that the spiral cable is connected between

the safety boxes from IN1 to IN2

Resetting the frame:

Press the DOWN button and adjust the frame to

bottom position. Press the DOWN button once

more and keep it pressed for 5 sec to reset the

control unit

Dismount the double safety between the motor legs

and the MOTOR output in the boxes. Mount the

motor cables between the motor legs and control

box instead. Attempt to do a reset. If only one leg is

driving, STOP! The other leg needs replacing.

If reset is successful, remount the double safety.