Casio FX-9750G Manuel Kullanım - Sayfa 8

Hesap Makinesi Casio FX-9750G için çevrimiçi göz atın veya pdf Manuel Kullanım indirin. Casio FX-9750G 12 sayfaları. 3. solve, differential/quadratic differential, integration, maximum/minimum value, and calculations
Ayrıca Casio FX-9750G için: Kullanıcı Kılavuzu (18 sayfalar), Ekler (10 sayfalar), Manuel (12 sayfalar), Manuel (19 sayfalar), Manuel (13 sayfalar), Manuel (10 sayfalar), Manuel (16 sayfalar), Manuel (12 sayfalar), Manuel (11 sayfalar), Manuel (14 sayfalar), Manuel (9 sayfalar), Ekler (18 sayfalar), Manuel (18 sayfalar), Manuel (17 sayfalar)

Sayfayı Yazdır

13 - 3

Drawing a Dynamic Graph

k k k k k Stop & Go Drawing

By selecting "STOP & GO

one by one. A graph is drawn each time you press w.

1. Display the coefficient value specification display and press 3 (SPEED).

2. Use f and c to select "STOP & GO (

3. Start drawing of the Dynamic Graph.

k k k k k Overwriting

CFX

By turning "On" the locus (Locus) setting of the Dynamic Graph, graphs are

sequentially drawn on the same display. The newest graph drawn is easily

identifiable because its color is different from graphs that were previously on the

display.

1. Display the coefficient menu. Next, display the set up screen and specify "On"

188

• Pressing A while the Dynamic Graph is being drawn changes to the drawing

speed setting display. The draw operation is suspended at this time, and you

can view the graph by pressing !6 (G ↔ T).

• Selecting "Cont" and then executing a Dynamic Graph operation causes the

graphing operation to repeat until you press A. Be sure that you do not forget

to stop the Dynamic Graph operation after you are finished. Allowing it to

continue will run down the batteries.

Example

To use Stop & Go to draw the same graph that you drew in the

previous example (page 184)

6(DYNA)

• Pressing A while the Dynamic Graph is being drawn changes to the drawing

speed setting display. The draw operation is suspended at this time, and you

can view the graph by pressing !6 (G ↔ T).

Example

To switch the locus setting on and draw the same graph that

you drew in the previous example (page 184)

for Locus and then press J.

" as the graph drawing speed, you can draw graphs

)" and press 1 (SEL) J.

···→

←···