AUDIOBYTE Hydra Z Kullanıcı El Kitabı - Sayfa 3

Medya Dönüştürücü AUDIOBYTE Hydra Z için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. AUDIOBYTE Hydra Z 11 sayfaları. Usb audio bridge

AUDIOBYTE TECHNOLOGIES

3) S/PDIF RCA output

4) AES/EBU output

5) I2S/LVDS output (HDMI connector, see next section for settings)

6) TOSLINK output

7) DC power input (5v dc, do not exceed 6v dc)

8) USB input (USB 2.0, type B)

Supported sample rates/clocks :

SPDIF & AES/EBU outputs : 44.1KHz – 192 KHz PCM, DSD64 via DoP

I2S output : 44.1 KHz – 384 KHz PCM , DSD64-256 native

TOSLINK output : 44.1KHz – 96 KHz PCM

WORDCLOCK : 44.1KHz – 384 KHz (depending on the sample clock of the played material)

MASTERCLOCK : 22.5792 or 24.576 MHz (idem with the above statement)

PHASE NOISE , WORDCLOCK : - 114 dBc/Hz @ 10 Hz

Note : all outputs are active simultaneously. Masterclock available on the I2S output can be set with

internal jumper J22. BNC wordclock or masterclock output setting can be altered with internal

jumper J23. DSD to PCM conversion can be enabled with jumper J21 assuming you have firmware

1.06 or more. See section "HYDRA Z special settings".

POWERING UP

1) In order to use Hydra Z, installation of drivers is necessary in Windows environment.

Please choose from the driver package available for download what fits your version of Windows.

ASIO package is available. For Mac and Linux users, the device is recognized natively (no drivers are

needed).

2) Connect your Hydra Z to a computer using a proper USB cable. The power USB led ("2"

from the front view diagram) will turn on. The default data led ("3" from the front view diagram)

will turn on. You are now ready to use your unit, after you will make the proper settings in your

playback software or OS environment.

3) You can optionally connect a external power supply to the DC input socket("7" from the

back view diagram). It can be either Hydra Z-PM (Z Power Module, recommended) or any low noise

5Vdc power supply, minimum 0.5A. The DC socket center pin is 2.35 mm type. When external power

is applied, the power USB led ("2" from the front view diagram) will turn off and the EXT power led

("1" from the front view diagram) will turn on.

SPECIFICATIONS, SOFTWARE

Hydra Z will support currently maximum sample rates of 384 KHz on PCM and 11.2 MHz

(DSD256) on DSD. On DSD material, both native DSD stream and encoded over PCM (DoP) are

available. The native DSD stream is available over I2S output, while DoP is available over S/PDIF

(RCA or BNC) and AES/EBU outputs. DSD over PCM (DoP) available rates are DSD64 and DSD128.

Recommended software player list :

HYDRA Z Owner's Manual