Free The Tone FF-1Y Ürün Yazılımı Güncelleme Prosedürleri - Sayfa 10
Kayıt Ekipmanları Free The Tone FF-1Y için çevrimiçi göz atın veya pdf Ürün Yazılımı Güncelleme Prosedürleri indirin. Free The Tone FF-1Y 10 sayfaları. Rf phase modulation delay
Ayrıca Free The Tone FF-1Y için: Kullanıcı El Kitabı (12 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar)
Sayfayı Yazdır
4. Connecting FUTURE FACTORY and MIDI Interface
1) Connect the MIDI interface's MIDI OUT terminal to FUTURE FACTORYʼs MIDI terminal, and switch the
MIDI IN OUT switch to "IN".
2) While holding down both the 【A-DLY-B SEL】 and 【SAVE】 switches on the FUTURE FACTORY , turn on
the power to it. The display indicates "00". Now the FUTURE FACTORY is ready to receive the data.
SIDE
INPUT LEVEL
A
( MONO )
5. Data Transmission
Click the "Send(F4)" but ton near the left top corner of the SysEx Librarianʼs main screen. Data
transmission starts as shown in the figure below.
The FUTURE FACTORY ʼs display starts counting up from "00". Data transmission will complete in about 60
seconds.
CAUTION!
NEVER TURN OFF THE POWER TO THE FUTURE FACTORY DURING DATA TRANSMISSION.
When the FUTURE FACTORY ʼs display counts up to "100" and stops, press the 【 SAVE】 switch, then the unit
will automatically initialize itself and the firmware update will be completed.
FRONT
REAR
LINE
INST
IN
B
A
OUT
( SERIES MODE )
MIDI
B
EXT
IN
OUT
10
927A001