AudioControl ACX-300.2 Hızlı Başlangıç Kılavuzu - Sayfa 5
Amplifikatör AudioControl ACX-300.2 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. AudioControl ACX-300.2 12 sayfaları. Compact high power all-weather 2-channel amplifier
Sayfayı Yazdır
8. High Pass Crossover – A crossover allows you to match a speaker
to the frequency range it is designed to handle. Choosing the
crossover point recommended by the speaker manufacturer will
provide increased speaker reliability and optimum sound quality.
The ACX-300.2 amplifier has selectable high pass crossover
frequencies at 80 Hz, 120 Hz, and a "bypass" option. The amplifier
reproduces the frequency range above the selected crossover
frequency.
9. Maximized – This LED will shine when the signal is approaching
the clipping point. With your source unit turned up to 75%, use
your gain controls to dial in the output by watching for this LED to
shine, then back it off just a touch.
10. GTO™ Signal Sense – In the ON position, the ACX-300.2 amplifier
will gracefully turn on when it detects an incoming audio signal
and turn off after a period of time when the audio signal fades
away to silence. In some situations, factory installed audio systems
may turn on or "wake up" due to convenience features like door
chimes, alarms or cell phone signals that trigger the source unit in
the vehicle to come on. To prevent these from turning your audio
system on unexpectedly, you can bypass the GTO™ circuit by mov-
ing the switch to the OFF position and use a switched 12v trigger
from the vehicle.
**Pro tip - if using speaker- level/high-level inputs, you'll
need some RCA ends on the ends of the speaker wire
to attached to the RCA inputs. Setting the Input Level
to High of course.
11. RCA Inputs – This is where you connect your source signal to. If
using low level signals, make sure your Input Level setting switch
is set to Low. If you are using high or speaker level signals, set your
Input Level to High.
11
5