AudioControl D-4.800 Hızlı Başlangıç Kılavuzu - Sayfa 5
Amplifikatör AudioControl D-4.800 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. AudioControl D-4.800 18 sayfaları. High power multi channel amplifier with dsp matrix processor
Ayrıca AudioControl D-4.800 için: Hızlı Başlangıç Kılavuzu (17 sayfalar)
Sayfayı Yazdır
Features continued
"""=::;=il
- - 0 0 0
10 11 12 13 14
12. Communications LED - This LED turns on when there is USB
activity between the D-4.800 and your computer during set
up.
13.
GTO™
Signal Sense
-
In the ON
position,
the D-4.800 amplifier
will turn on gracefully when it detects an incoming audio signal
on inputs 1 and 2, and it will turn off after a period of time when
the audio signal fades away to
silence.
In some situations, factory
installed audio systems may turn on or"wake
up"
due to conve-
nience features like door
chimes, alarms,
and cell phone signals
that trigger the source unit in the vehicle to come on. To prevent
these from turning your audio system on
unexpectedly,
you can
bypass the
GTO™
circuit by moving the
GTO™
switch to the OFF
position and use a switched 12-volt signal connected to the
Re-
mote In terminal
instead.
14.Maximized Input LEDs
-
These LEDs illuminate when a
maxi-
mum audio signal is present on any of the analog audio
inputs.
During
power-up,
these LEDs and the output LEDs will turn on
momentarily,
one after the other. Turn down the levels if these
LEDs are on a lot.
15 16
15. Maximized Output LEDs - These LEDs illuminate when there is
maximum signal present on any of the analog audio
outputs.
Turn
down the output levels if these LEDs are on a lot.
16.
MILC-
Source Clip LED
-
The
MILC™
(Maximum Input Level
Control) patent-pending level-setting circuit (on inputs 1-2
only)
prevents clipping and damaging distortion. It calculates when the
waveform of an incoming audio signal is
clipping,
and if it is, this
LED will fulfill its destiny and shine
forth.
With this advanced feature, you are able to optimize the level of
the incoming audio signal until the Source Clip LED is just about
to come
on.
If the LED comes on during normal operation, you
should adjust the level of the audio signals before they reach the
D-4.800.
After an interview with the lead engineer included the words
"differential
calculus;'
and some hieroglyphics on a chalk board,
the technical writer's eyes glazed over and he had to be brought
round with a nice cup of tea and two donuts with sprinkles.
AudioContPOI
®
Making Good sound Great
~
s