AudioControl DQ-61 Manuel - Sayfa 6

Medya Dönüştürücü AudioControl DQ-61 için çevrimiçi göz atın veya pdf Manuel indirin. AudioControl DQ-61 19 sayfaları. Six channel line output converter with signal delay, equalization and accubass for interfacing with factory installed audio systems

Sayfayı Yazdır

Signal Delay Mode: This allows the user to put the DQ-61 into a Set-Up

➎

mode and adjust the signal delay settings using the dash control. Turn knob to

the right until the Set-Up LED comes on. When done, turn knob to the left,

Normal setting for regular music listening.

Ground: Connect to a good, verified chassis ground (the battery comes to

➏

mind.) Warning: Factory ground wires typically have multiple devices con-

nected to them so it is not recommended to use them.

+12V Power: Connect to a good source of 12-volt power (the battery

➐

comes to mind)

Remote In: In some unusual installations, you may not want to use the

➑

GTO™ to turn on your system due to secondary functions with factory in-

stalled source unit. For these cases the DQ-61 can be turned on remotely with a

+12-volt trigger.

Remote Out: Outputs 12 volts with 1 amp of current when the DQ-61

➒

is powered up, so you can turn on external devices like signal processors and

amplifiers with this wire.

Maximized Indicator: This brightly colored LED indicates when the sig-

➓

nal level coming into your DQ-61 is just below clipping. When properly level

matched, this LED should flicker occasionally when your system is playing at

its maximum volume level.

Power: If you have connected all of your power wires correctly, this light

should be bright red when your system turns on.

Remote Level Control (ACR-3): In the Set-Up mode this control allows

for setting the signal delays, and in the Normal mode, it gives the user control

over the Subwoofer/Ch3 level output. Additionally, in the Normal mode, when

you tap this switch you will bypass the equalization, signal delay , and Accu-

BASS processing of your DQ-61 so you can compare the sound.

Pre-Amp Outputs: These RCA plugs should be connected to the next

component after the DQ-61, such as a crossover or amplifier. Do not connect

any speakers directly to your DQ-61. (Definitely don't connect to any home

appliances, like your blender or toaster.)

Output Level Controls: These knobs allow you to adjust the signal level

from your source unit to match the input of your after-market amplifiers.

Channel Summed Indicators: These green (like our grass) LED indi-

cators let you know which channels are being summed into the main inputs.

Under the cover of your DQ-61 are jumpers that will allow you to sum selected

channels into the main and rear (#1) channels.

page 6