Acer XGA single chip 0.7" DLPTM projector Kullanıcı Kılavuzu - Sayfa 31

Projektör Acer XGA single chip 0.7" DLPTM projector için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Acer XGA single chip 0.7" DLPTM projector 34 sayfaları.

Sayfayı Yazdır

Warning: Lamp

compartment is hot!

Allow it to cool down

before changing lamp!

Warning: To

reduce the risk of

personal injury, do not

drop the lamp module

or touch the lamp

bulb. The bulb may

shatter and cause

injury if it is dropped.

Replacing the lamp

The projector will detect the lamp life itself. It will show you a

warning message "Lamp is approaching the end of its useful life

in full power operation. Replacement Suggested!" When you see

this message, changing the lamp as soon as possible.

Make sure the projector has been cooled down for at least 30

minutes before changing the lamp.

Lamp Changing Procedure:

1. Turn the power off the projector by pressing the Power

button.

2. Allow the projector to cool down at least 30 minutes.

3. Disconnect the power cord.

4. Use a screwdriver to remove the screw from the cover.

5. Push up and remove the cover.

6. Remove the 2 screws from the lamp module.

7. Pull out the lamp module.

To replace the lamp module, reverse the previous steps.

Appendices

... English