dupol DP Door-I Kullanıcı Kılavuzu - Sayfa 3

Kapı Açıcı dupol DP Door-I için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. dupol DP Door-I 6 sayfaları. Wifi based remote gate control unit
Ayrıca dupol DP Door-I için: Kullanıcı Kılavuzu (14 sayfalar)

Sayfayı Yazdır

Operating

Device contains output terminals for a dry contact (relay output) with no contact by default (Normally

Open type). On a start signal the output relay is energized for 1 second, providing a contact on output

terminals for that time. This "contact signal" is convenient for „gate START/STOP/REVERSE" input of most

gate drive controll unit.

The MOTOR+ and the MOTOR- inputs are monitoring the voltage and polarity of the motor supply itself.

This way, the information of direction for the gate moving is sent to the application. Also, the period of the

applied voltage is also monitored, therefore the position of the gate is determined – for example, if the

voltage was applied for shorter than the gate closing time, the gate did not close completely.

If the motor used for gate is not suitable for the DP Door-I Gate Opener input ( if it is 230V AC Motor) then

the isolated contact input ( end contact 2) can be used to check the gate closed status.

Setting

Setting the device Wi-fi connection

Press shortly the WIFI SETUP pushbutton and the green/red LED alternate blinking will be signaling that

device is in „HOTSPOT" mode, it is transmitting a personal WI-fi network with DEVICE name.

✓

Use any personal device (phone, tablet) to connect to that Wireless network.

✓

After a successful connection open a web browser and enter a site name wifisetup.eu.

This is the device connection setup page and you can see it contains fields to set up

2 different WIFI connections - a primary, and a "backup". Selecting the appropriate SSID (network

name) and password will try to establish connection. If you have active DHCP (in the router), the device

will get an IP address.

✓

When the received IP address is displayed, save the settings an press shortly the WIFI SETUP

pushbutton. The device will restart in Idle mode and when the connection is established (normally, it

will take few seconds after restart), a green LED will start blinking.

All other settings for the device operation are available in the smartphone application.

DP Door-I Gate Opener

3 EN