Audiolab M-ONE Kullanıcı Talimatları - Sayfa 8

Amplifikatör Audiolab M-ONE için çevrimiçi göz atın veya pdf Kullanıcı Talimatları indirin. Audiolab M-ONE 13 sayfaları.

!3!

7; !Pqfsbujpo!.!3!

Playing Music via Bluetooth

You can wirelessly connect M-ONE to a music source via Bluetooth wireless technology.

Volume up/down, standby and mute in/out can be controlled from either your Bluetooth

source or from M-ONE. Other functions – play, pause, previous track, next track, fast

forward and reverse are all controlled from your Bluetooth source only.

Playing Music via Bluetooth

You can wirelessly connect M-ONE to a music source via Bluetooth wireless technology.

Volume up/down, standby and mute in/out can be controlled from either your Bluetooth

source or from M-ONE. Other functions – play, pause, previous track, next track, fast

forward and reverse are all controlled from your Bluetooth source only.

Select M-ONE as a music output device on your Bluetooth source to start playing music.

To disconnect the Bluetooth music source either

•Move the Bluetooth source beyond the communication area

•Turn off the connected device or turn off its Bluetooth function

Note:

If you have difficulty connecting M-ONE to a Bluetooth device, please try selecting "Forget

this Device" on your source unit and then go through the connection procedure again.

Selecting a Digital Filter

M-ONE has 3 PCM filters and 4 DSD filters available. Press the remote control MENU key to

enter menu mode, press

to access the "Digital Filter" or "DSD Bandwidth" menu

page, press

to enter the filter page, press

press

again to confirm the chosen filter. Pressing the SEL knob on the front panel can also

enter the menu mode, rotating this knob turns the menu page to "Digital Filter " or "DSD

Bandwidth", press the SEL knob again to enter this page and then rotate the knob to change

filters, press the SEL knob again to select a filter.

The "Sharp Rolloff" filter typifies industrial standard characteristics (-6dB at 1/2 Fs with

significant time-domain ringing ) and is included here for comparison purposes.

The "Slow Rolloff" filter starts rolling off at a lower frequency than the Sharp Rolloff filter but has

a gentle rate of attenuation and significantly less "time-domain ringing". It is not recommended

to use this in normal operation, unless the digital signal from a source is very poor and cannot

play with other filters.

The "Minimum Phase" filter has a gentle attenuation slope similar to the Slow Rolloff option,

however it exhibits no pre-ringing in the time domain. It can be likened to an analogue filter

applied in the digital domain.

For DSD mode, there are four filters "Normal", "50K", "60K" and "70K" with cutoffs at

47k, 50K, 60k, 70k. The user can adjust the IIR bandwidth by selecting different filters to get

particular sonic nuances.

Page 7

again to select a different filters,