Daniela DANDW45BS Kullanıcı Kılavuzu - Sayfa 14
Bulaşık Makinesi Daniela DANDW45BS için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Daniela DANDW45BS 18 sayfaları. 45cm stainless steel electronic dishwasher
Sayfayı Yazdır
TROUBLESHOOTING TIPS
BEFORE CALLING FOR SERVICE
Reviewing the charts on the following pages may save you from calling for service.
PROBLEM
POSSIBLE CAUSES
Dishwasher
Fuse blown, or the circuit
doesn't start.
break tripped.
Power supply is not
turned on.
Water pressure is low.
Door of dishwasher not
properly closed.
Water not
Twisted or trapped
pumped form
drain hose.
dishwasher.
Filter clogged.
Kitchen sink clogged.
Suds in the tub.
Wrong detergent.
PA G E 2 6
P
I
02 9604 1226
E
I
WHAT TO DO
Replace fuse or reset circuit breaker.
Remove any other appliances sharing the same
circuit with the dishwasher.
Make sure the dishwasher is turned on and the
door is closed securely. Make sure the power cord
is properly plugged into the wall socket.
Check that the water supply is connected properly
and the water is turned on.
Make sure to close the door properly and latch it.
Check the drain hose.
Check coarse the filter.
Check the kitchen sink to make sure it is draining well.
If the problem is the kitchen sink that is not draining,
you may need a plumber rather than a serviceman
for dishwashers.
Use only the special dishwasher detergent to avoid
suds. If this occurs, open the dishwasher and let suds
evaporate. Add 1 gallon of cold water to the bottom
of the dishwasher.
Close the dishwasher door, then select any cycle.
Initially, the dishwasher will drain out the water.
Open the door after draining stage is complete
and check if the suds have disappeared.
Repeat if necessary.
W
|
danielaappliances.com.au
PROBLEM
POSSIBLE CAUSES
The dishes
The dishes were not
are not clean.
loaded correctly.
The program was not
powerful enough.
Not enough detergent
was dispensed.
Items are blocking the
movement of the spray arms.
The filter combination is
not clean or is not correctly
fitted in the base of wash
cabinet. This may cause
the spray arm jets to
get blocked.
Cloudiness
Combination of soft water
on glassware.
and too much detergent.
Black or gray
Aluminum utensils have
marks on dishes.
rubbed against dishes.
Detergent left in
Dishes block
dispenser cups.
detergent cups.
The dishes are
Improper loading.
not drying.
Too little rinse-aid.
Dishes are removed
too soon.
Wrong program has
been selected.
Use of cutlery with
a low-quality coating.
P
I
02 9604 1226
E
I
WHAT TO DO
See notes in "Loading the Dishwasher Baskets".
Select a more intensive program.
See "Wash Cycle Table".
Use more detergent, or change your detergent.
Rearrange the items so that the
spray can rotate freely.
Clean and/or fit the filter combination correctly.
See "Cleaning the Spray Arms".
Use less detergent if you have soft water and
select a shortest cycle to wash the glassware and to
get them clean.
Use a mild abrasive cleaner to eliminate those marks.
Re-loading the dishes properly.
Load the dishwasher as suggested in the directions.
Increase the amount of rinse-aid/refill the
rinse-aid dispenser.
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam can
escape. Begin unloading the dishwasher only once
the dishes are barely warm to the touch. Empty the
low basket first. This prevents water form dropping
off dishes in the upper basket.
In short program the washing temperature is lower.
This also lowers cleaning performance. Choose a
program with a long washing time.
Water drainage is more difficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
W
|
danielaappliances.com.au
PA G E 2 7