Brainworx bx_rockrack Manuel - Sayfa 7

Müzik Enstrümanı Amplifikatörü Brainworx bx_rockrack için çevrimiçi göz atın veya pdf Manuel indirin. Brainworx bx_rockrack 11 sayfaları. The first guitar amp simulation plugin.

Sayfayı Yazdır

FILTER MODULE:

There are 3 different filters in bx_rockrack. The SHRED filter is processing the sound POST AMPLIFIER

(after the amplifier), while the TIGHT and SMOOTH filters process the direct guitar sound before it hits

the amplifier stage (see Signal Flow Chart on Page 4).

TIGHT ON/OFF:

Switches the TIGHT filter active or inactive (details below).

TIGHT (30 Hz – 3,000 Hz):

If you experience rumbling problems from your guitar (unwanted low end distortion or hum problems)

use this filter. Settings higher than 200 Hz can create audible effects which might be nice for intro

sounds ("kitchen radio effect") as your amps will sound really thin and powerless if you cut away a lot of

low end in your guitar sound.

SMOOTH ON/OFF:

Switches the SMOOTH filter active or inactive (details below).

SMOOTH (3,000 Hz – 35,000 Hz):

With the SMOOTH filter you can cut away ultra-high frequencies of your guitar before the amplifier.

This is a great tool if you run into crossfeed or hiss problems due to poorly shielded pickups, broken

cables or atomic power plants next to the studio.

SHRED ON/OFF:

Switches the SHRED filter active or inactive (details below).

SHRED: (taken from the established bx_shredspread plugin)

The SHRED filter is an original Brainworx design to phatten up your rock guitars and to smooth out

jazzy clean sounds. It will bring out your guitar sounds in a mix quite well while defeating harsh and

unwanted frequencies. It´s a one-knob sound tool, please just use your ears.