AUDIOLINE TEL6 Kullanım Talimatları

Telefon AUDIOLINE TEL6 için çevrimiçi göz atın veya pdf Kullanım Talimatları indirin. AUDIOLINE TEL6 2 sayfaları.

Sayfayı Yazdır

- General Information -

Please read these operating instructions carefully. If you

Temperature and ambient conditions -

should have any questions, please contact our Service

is designed for use in protected rooms with a temperature

Department on the Hotline number 0180 5 00 13 88 (costs

range of 10 °C to 30 °C. The telephone must not be

Telekom by printing: 12ct/min). Under no circumstances

installed in damp rooms such as a bathroom or laundry

open the unit yourself and do not try to carry out your own

room. Avoid proximity to sources of heat such as radiators

repairs. For any claims under the warranty, please refer to

and do not expose the unit to direct sunlight.

your dealer.

Location -

Intended use -

This telephone is designed for use

vicinity of other electrical equipment such as microwaves

connected to an analogue telephone line (PSTN) in

or hi-fi systems, as this may result in mutual interference.

Germany. However, due to differences in the services

The location has a decisive influence on the trouble-free

provided by the various telecommunications providers, we

operation of the telephone.

cannot guarantee that the telephone will work properly

when connected to all telecommunications terminal lines.

Place the telephone on a flat and non-slip surface. The

The telephone is prepared for connection to a TAE phone

feet do not normally leave any marks on the surface.

jack with F/N coding and can be used together with other

However, due to the large number of varnishes and

equipment such as a fax, answering machine, or a

surfaces in use, it may not be possible to prevent marks

modem. Plug the connecting phone cable only into the

occurring on the surface due to the feet of the unit.

telephone plug socket provided for this purpose. Do not

Do not use the telephone in areas where there is a risk of

replace the plug of the connecting phone cable.

an explosion.

Private exchanges -

The telephone can also be

Excessive exposure to smoke, dust, vibrations,

connected to a private exchange. You can find out from

chemicals, moisture, heat or the direct rays of the sun

the dealer from whom the equipment was purchased

must be avoided.

whether your telephone will work on your private

exchange without any problems. Due to the large number

Cleaning and care -

of different private exchanges, it is not possible to

cleaned with a soft, dry, lint-free cloth. Never use cleaning

guarantee this function.

agents, particularly aggressive solvents. No attention is

necessary apart from cleaning the housing occasionally.

Disposal -

If the useful life of the complete equipment has

The rubber feet of the telephone are not resistant to all

expired, please dispose of it carefully in accordance with

cleaning agents. The manufacturer can therefore not

the statutory requirements and in a manner friendly to the

accept any liability for possible damage to furniture or the

environment.

like.

CE mark - The telephone complies with the basic

requirements of the R&TTE Directive This is confirmed by

the CE mark.

- Operation -

Making a call using the speed dial buttons

Muting the microphone

Lift the receiver.

You can switch off the microphone during a call using the

Press the speed dial button

mute button, . It is thus possible to speak without the

Now press the required storage location between 0

other party hearing you. The loudspeaker remains

and 9 on the keypad. The stored number will now be

switched on and you can continue to hear the other party.

dialled automatically.

To end the call, replace the receiver.

To mute the microphone, press and hold the mute button

once while a call is being made.

Interesting note!

With your telephone you can make calling by way of the

To switch the microphone on again, release the mute

private telephone network providers considerably easier.

button

and you will be able to continue your call as

Save the access numbers to the private network providers

normal.

and the actual telephone numbers separately in different

storage locations. First dial the memory location for the

Saving numbers under the speed dial buttons

private network provider and then a direct dial button or

over the speed dial button the memory location for the

Lift the receiver.

required telephone number or dial the required telephone

Press the store button

number manually.

Enter the required telephone number with a maximum

of 16 digits using the number pad.

Private exchanges - Setting up for T-NET

Note:

If you enter the wrong number, you can break

You can use the "R" signal button on your telephone on

off the process at this point by replacing the receiver

private exchanges and when using DEUTSCHE

on the rest.

TELEKOM's T-Net functions.

Press the store button

Now select a speed dial storage location by pressing a

Private exchanges -

number between 0 and 9 on the number pad.

telephone to a private exchange, you can use all the

Replace the receiver on the rest to complete the save

facilities such as call transfer, automatic recall, etc. The "R"

procedure.

signal button gives you access to these facilities. The

FLASH time "100ms" will be required on a private

Tips on storing numbers:

exchange. To make this setting, move the slide switch on

Storage locations that have already been used cannot be

the right side to the "100ms" position. You can find out

erased. Simply save a new number in the storage location

from the dealer from whom the equipment was purchased

that you want to erase.

whether your telephone will work on your private exchange

without any problems and which other facilities you will

have access to.

- Operational Elements -

- General Information -

The telephone

Disconnect button/receiver rest

Save button

Redial

Speed dial button

R signal button

Right side

Ring tone switch

Do not set up the telephone in the immediate

FLASH switch

Inside the receiver

Mute button

ABC

DEF

GHI

JKL

MNO

PQRS

TUV

WXYZ

The surface of the case can be

- Operation -

T-NET functions -

Your telephone supports the most

important DEUTSCHE TELEKOM added value services

(e.g. brokering, call waiting, three-way conferencing, etc.).

Please contact DEUTSCHE TELEKOM to gain access to

these functions (some of which are subject to charge).

When using T-NET functions, move the slide switch on the

right side to the "300ms" position.

Dialling telephone numbers when using on private

exchanges

With private exchanges, it is necessary to dial a certain

number (e.g. "9" or "0") in order to obtain a dialling tone for

an outside line on the extension. With some, older private

exchanges, it takes some time before the dialling tone can

be heard. Especially for these private exchanges, an

automatic pause can be inserted after connecting to the

outside line so that you can dial directly without waiting for

the dialling tone.

Press the redial button

the outside line and the actual telephone number. After

connecting to an outside line your telephone will wait for 3

seconds before dialling the actual telephone number.

If you have connected your

You can store the pause under the speed dial buttons.

- Commissioning -

General Information

NOTE! Before commissioning, it is essential that you read

the General Information at the beginning of this manual.

Check contents of pack

The following items are supplied

- one telephone with telephone connecting cable

- one instruction manual

100/300ms

Connecting the telephone

Connect the firmly installed telephone cable to the

telephone socket.

The telephone works using the tone dialling system.

Wall mounting

Your telephone is also suitable for wall mounting. Use two

flat head screws for fixing. Drill two holes horizontally side

by side, 83 mm apart, and leave the screws protruding

from the wall by 5mm. Now place the telephone over the

screws and push it slightly downwards.

If you are using the telephone fitted to the wall, you can

hang the receiver on the telephone without hanging up.

You will find a small hook for this purpose at the upper end

of the receiver rest.

- Operation -

- Important information -

Fault finding

Remove all extra telephone equipment and connect only

the telephone directly to the telephone socket.

If the fault is still present, connect another telephone (if

available) to the telephone socket. The results will show

you whether the fault lies with the unit or with the

telephone line.

In the case of technical problems you can also contact our

Service Department on the Hotline number

0180 5 00 13 88 (costs Telekom by printing: 12ct/min).

Guarantee

AUDIOLINE equipment is manufactured and tested in

accordance with the most up to date production methods.

Selected materials and highly developed technology

ensure trouble-free operation and long life. If your unit

should develop a fault within the guarantee period,

once between the number for

however, please contact the shop where you bought your

AUDIOLINE equipment exclusively and have your

purchase receipt available for inspection. The warranty

period is 24 months calculated from the day of purchase.

Warranty conditions:

Within the guarantee period, all defects due to material or

manufacturing faults will be repaired free of charge. The

guarantee is invalidated if the equipment has been

tampered with by the purchaser or third parties. Any

damage caused by improper handling or operation, by

incorrect positioning or storage, by improper connection or

installation or by excessive force or other external

influences is not covered by the guarantee. In the case of

complaint, we reserve the right to repair or replace

defective parts or to exchange the equipment.

- Operation -

Making a call

Your telephone can be used like any conventional

telephone.

Lift the receiver and wait until you hear the dialling

tone.

Now dial the required telephone number.

To end the call, replace the receiver on the rest. You can

end the current call by using the disconnect button and

you will immediately obtain a new dialling tone.

Receiving calls

When a call comes through, you will hear the ringing

tone. The call can now be accepted using the receiver.

Redial facility

If a connection that you have dialled is engaged or you

were unable to get through to anybody, simply replace

the receiver. The last number dialled remains stored in

the telephone automatically. To use the redial facility,

proceed as follows:

Lift the receiver and press the redial button

The

stored redial number will now be dialled.

Adjustable ring tone

By means of the slide switch

you can choose the

settings

(loud) or

(soft) to match the volume of the

ringing tone to your requirements. If at any time you do

not want to be disturbed, use the setting

(off).

- Important information -

Exchanged parts or exchanged equipment become our

property. Claims for compensation are excluded insofar as

they do not relate to criminal intent or gross negligence on

the part of the manufacturer. All guarantee claims according

to these conditions must be raised exclusively with your

dealer. Rights under the guarantee can no longer be

enforced after the expiry of 24 months from purchase and

delivery of our products. In the case of unnecessary or

unjustified demands on the customer service department,

we will levy our usual service charges for materials, time,

postage and packing. Any complaints must be reported as

soon as a problem is found. The guarantee is valid within

the German Federal Republic.

Declaration of Conformity/CE mark

The telephone complies with the basic requirements of the

R&TTE Directive "1999/5/EEC". This is confirmed by the CE

mark.

For the complete Declaration of Conformity, please use the

free download from our web site www.audioline.de.

- Notizen / Notes -