Audiomedia AMD 808BT Kullanıcı Kılavuzu - Sayfa 4

Araç Alıcısı Audiomedia AMD 808BT için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Audiomedia AMD 808BT 20 sayfaları. Bluetooth cd/mp3 player with radio am/fm rds usb-sd/mmc built in

Sayfayı Yazdır

INSTALLATION

Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up

properly and the unit and system work properly.

Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts

can cause malfunctions.

Consult with your nearest dealer if installation requires the drilling of holes or other modifications of

the vehicle.

Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a

sudden stop, like an emergency stop.

If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance.

Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or

from hot air, from heater, or where it would be subject to dust dirt or excessive vibration.

Be sure to remove the front panel before installing the unit.

DIN FRONT/REAR-MOUNT

This unit can be property installed either from "Front" (conventional DIN Front-mount) or "Rear"(DIN

Rear-mount installation, utilizing threaded screw holes at the sides of the unit chassis). For details, refer

to the following illustrated installation methods A and B.

DIN FRONT-MOUNT (Method A)

Installation the unit

182

Removing the unit

Trim Plate Installation:

Push the trim plate against the chassis until it is fitted.

You must do this before you install the front panel, otherwise it can't be attached.

1. Dashboard

2. Holder

After inserting the half sleeve into the dashboard,

select the appropriate tab according to the

thickness of the dashboard material and bend

Them inwards to secure the holder in place.

3. Screw

1. Dashboard

2. Nut (5mm)

3. Spring washer

4. Screw (5x25mm)

5. Screw

6. Support Strap

Be sure to use the support strap to secure the

back of the unit in place. The strap can be bent by

hand to the desired angle.

7. Plain washer

a. Frame

b. Insert fingers into the groove in the front of frame

and pull out to remove the frame. (When

re-attaching the frame, point the side

with a groove down wards and attach it.)

c. Insert the levers supplied with the unit into the

grooves at both sides of the unit as shown in figure

until they click. Pulling the levers makes it possible

to remove the unit from the dashboard.

GB - 3

30°