Dankoff Solar Water Feature Kurulum ve Servis Kılavuzu - Sayfa 6

Su Pompası Dankoff Solar Water Feature için çevrimiçi göz atın veya pdf Kurulum ve Servis Kılavuzu indirin. Dankoff Solar Water Feature 18 sayfaları. Solution kit

Sayfayı Yazdır

4. MECHANICAL SYSTEM HOOKUP

Mount the Pump

The pump may be mounted horizontally or vertically. If mounted vertically, suspend from a rope and face the pump

head downward. Rigid mounting is not required in most installations. Observe the pump and ensure that it does not

overstress or loosen pipes as it starts. In non-battery systems like The Water Feature Solution Kit, starting is

gradual and the pump does not torque with the start. Mounting the pump directly to a wall or wood floor will

increase the noise heard in that structure.

Take every precaution to prevent the pump from freezing. The forged brass pump head will survive most light

freezes, but a hard freeze may damage it. If the pump is insulated for freeze protection, keep the motor exposed to

prevent overheating.

Once you have determined where the pump will be mounted and covered, use the flanges on the pump body to

mount it to a stable location if desired. Follow the chart below in determining the proper location and orientation of

the pump.

It is important to minimize Suction Lift. Suction lift refers to the pressure (negative pressure) on the suction (inlet)

side of the pump. As the vertical distance from the pump inlet to water increases, the suction lift pressure also

increases. The practical suction/intake pipe limit for any pump is 20 vertical feet to water at sea level (subtract 1 ft.

for every 1000 ft. of elevation). Limiting the pipe length to 2 to 3 feet will allow the pump to run quietly and more

reliably. Placing the pump downhill from the water source also helps to minimize suction lift.