DANLERS ControlZAPP CZ CEFL Kurulum Notları - Sayfa 2

Anahtar DANLERS ControlZAPP CZ CEFL için çevrimiçi göz atın veya pdf Kurulum Notları indirin. DANLERS ControlZAPP CZ CEFL 2 sayfaları. Ceiling flush mounted switch

Sayfayı Yazdır

Installation procedure

1. Please read these notes carefully before commencing work. In case of doubt

please consult a qualified electrician. Ensure wires and cables are securely held

within the connection terminals.

IMPORTANT: The CZ CEFL DALI VF Control Unit clock battery must be

engaged (ON) prior to installation by switching the RED dip switch (see

diagram D) to the DOWN position.

2. POSITIONING: The CZ CEFL DALI VF switch should be installed to achieve

correct coverage of the area, see diagram B. If the photocell override facility

(enabled via ControlZAPP app) is required, the switch must be located above

an area where daylight can give greater illumination than the artificial light. Avoid

locating this product where it is exposed to drafty conditions (exposed lobbies,

open ceiling voids or near fans) or near heat sources. To cover large areas PIRs

should be spaced in a 5 metre grid formation.

3. Disconnect the ControlZAPP device from the circuit before performing insulation

testing of the wiring circuit.

4. Do not connect on a circuit with large inductive loads, as induced spikes may

cause false triggering or damage the device.

5. CZ CEFL DALI VF must be connected to its ControlZAPP Power Supply via the

ControlZAPP communication cable provided, for wiring see diagram C.

NOTE: The use of non ControlZAPP connectors may damage the CZ CEFL DALI

VF device and will invalidate the warranty.

Settings and calibration

NOTE: ALL settings are adjusted by ControlZAPP App as specified in the

ControlZAPP App User Guide (downloadable from the DANLERS website)

including: MODE settings, SCHEDULER settings and photocell settings and

intelligent photocell calibration procedure.

MODE settings include: Detect Movement (enable or disable), Sensitivity, Short

Visit Mode (with timer), Turn ON automatically (Presence detection or Absence

detection), Turn OFF timeout (from10sec to 23hrs 59min 59sec), Respond to

Daylight (enabled or disabled) the calibration process must be run for the intelligent

photocell to work. Delay before ON or Delay before OFF timers, Scene Recall (ON

or OFF).

SCHEDULER settings include:

DAY TYPES (defining times for each of the different Modes to occur).

WEEKLY SCHEDULE (defining which Day Types are assigned to different days of

the week).

EXCEPTIONS (defining exceptions to the schedule such as holidays).

VIEW ON CALENDAR (overview of schedule).

A: Mounting diagram

CEILING VOID

(At least 78mm deep)

75mm circular hole

cut for PIR switch

B: Detection diagram

Strong detection zone

i.e. person moving arm

or walking towards PIR

up to 5m

up to 7m

C: Wiring diagram

DALI Control Lines

Volt Free,

Normally

Open

Supply

Voltage

Neutral

D: Connector diagram

IMPORTANT

Red dip switch (MUST be

switched DOWN (towards lens)

to engage clock battery ON)

Power Supply

For optimum coverage

recommended

mounting height: 2.4 to 5m

Secondary detection

zone i.e. person

walking perpendicular

to PIR

VF1

VF2

Control Unit

Telejack connector