DANLERS BMPIRSP Kurulum Notları - Sayfa 2

Aksesuarlar DANLERS BMPIRSP için çevrimiçi göz atın veya pdf Kurulum Notları indirin. DANLERS BMPIRSP 2 sayfaları. Batten mount pir occupancy switches

Sayfayı Yazdır

Installation procedure

1. Please read these notes carefully before commencing work.

In case of doubt please consult a qualified electrician.

Make sure the power is isolated from the circuit.

2. Remove the 20mm knockout from the end of the lighting batten.

3. Making reference to diagram A: Remove the 20mm thread from the

PIR and insert it through the 20mm knockout hole with the thread

facing outwards

4. Feed the trailing wires through the thread and with the PIR facing

downwards tighten the 20mm thread.

5. The trailing wires should be connected to the ballast as:

Brown - Live supply. Blue - Neutral supply. White - Switched Line to ballast.

6. Once the wiring has been completed and verified, switch on the supply

and test the operation.

Set-up

7. When powered up, (after 1 minute stabilisation time) turn lux pot

fully clockwise and time pot fully anticlockwise.

8. Press the button for approximately 0.5s. The LED will go green indi-

cating the LUX cell is active. (Or press and hold button for approx. 4

seconds – LED goes RED indicating Lux cell INACTIVE). Repeating

these steps will toggle the functionality.

9. If lux cell active, vacate area until PIR switch switches the load off

(should be after 10 seconds).

10. With the LUX as desired on desktop from daylight ONLY (no artificial

light), wind the lux pot anticlockwise whilst waving your hand in front

of the PIR cell. When the PIR switches the load ON, stop turning the

pot. The Lux inhibit level is now set.

11. Turn the PIR time to the desired timeout.

Precondition

Power-up Condition

Lux Cell Inactive

Relay OFF

Relay comes ON for 1 Min. After 1 min. ready for detection.

Lux Cell Active

Relay ON

Relay stays ON for 1 Min. After 1 min. ready for detection.

Lux Cell Active

Relay OFF

Relay comes ON for 1 Min. After 1 min. ready for detection.

Lux Cell Inactive

Relay ON

Relay stays ON for 1 Min. After 1 min. ready for detection.

A: Installation diagram,

viewed from below

B: Detection range

BMPIR5M

For optimum

coverage

100°

recommended

mounting

height: 2.4

to 5m

up to 5m

BMPIRSP

For optimum

coverage

recommended

mounting

20°

height: 2.4

to 5m

up to 1.5m

C: Lux

adjustment

D: Time

adjustment

To light

fitting

ballast

BMPIR10M

For optimum

coverage

112°

recommended

mounting

height: 2.4

to 5m

up to 10m

BMPIRRH

For optimum

coverage

100°

recommended

mounting

height: 2.4

PIR head - key components

PIR Lens

Lux cell

Lux setting

Lux Cell

Time

delay

setting

Dual colour LED

RED - PIR active, Photocell inactive

GREEN - PIR and Photocell override ON (passive LUX)

Mode