Danley TH412 Kullanıcı El Kitabı - Sayfa 4

Subwoofer Danley TH412 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Danley TH412 8 sayfaları.
Ayrıca Danley TH412 için: Kullanıcı El Kitabı (8 sayfalar)

Sayfayı Yazdır

Section

Your New Subwoofer

1.1

Unpacking

For most of the Danley Sound Labs line we recommend that it be unpacked by two or more people. Refer to the spec sheet for

product weight. Remove tape and open top flaps. Lay the box on its side and slide the subwoofer out. Remove the packaging

wrap.

1.2

Inspection

Check to make sure the product is not missing hardware of any kind. If any brackets or additional accessory hardware is missing,

please don't hesitate to contact Danley Sound Labs.

1.3

Shipping Damage

If your subwoofer appears to have been damaged in shipping, please take clear photographs and contact Danley Sound Labs

immediately.

Section 2

2.1

THE TAPPED HORN

The Danley Tapped Horn Subwoofer™ is a proprietary design which allows us to build physically small subs which are very

efficient especially at the low end of their range and are virtually linear in their passband. Subjectively the TH series produce

very deep bass from generally very small boxes. They are unlike conventional horns in that combining multiple TH boxes together

results in more output, but not significantly more extension.

2.2

THE DANLEY BASS HORN

The DBH subwoofer is a Danley take on a conventional design. The DBH subs feature a front loaded, folded horn design. The

DBH subs behave conventionally in that adding boxes together not only increases the output, but extends the low frequency

response downward.

Section 3

3.1

What Size Amplifier to Use

Selecting the right amplifier for your subwoofer depends on a variety of factors and uses. The owner is ultimately responsible for

choosing the best amplifier or amplifiers for the application. We recommend choosing an amp that is rated no less than continuous

and no higher than program. Please note "Continuous" does not mean "forever"! Most subwoofer manufactures, including Danley

Sound Labs, subscribe to the AES standards for subwoofer power ratings.

3.2

Connecting to the Tapped Horn

Your Danley subwoofer has two NL4 ("speak-on") connectors located on a panel on the rear of the box. With the exception of

the TH812, TH221, TH412, all TH series subwoofers are wired as passive. The two NL4 connectors are wired parallel.

Pinout: Passive

Positive

amp 1

1 -

Negative amp 1

Pass Through

2 -

Pass Through

Page | 4

DANLEY OWNER'S MANUAL

Understanding the Difference

Initial Set Up

Pinout: Bi-amp

1+ Positive

amp 1

1 - Negative amp 1

2+ Positive

amp 2

2 - Negative amp 2