Belcat UK-300T Kullanıcı Kılavuzu

Amplifikatör Belcat UK-300T için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Belcat UK-300T 3 sayfaları. 2band eq with chromatic led tuner

Sayfayı Yazdır
Belcat UK-300T Kullanıcı Kılavuzu
UK-300T USER'S MANUAL
2Band EQ with Chromatic LED tuner
1
2
3
1. Tuner LED Display
2. Bass
3. Treble
4. Volume Knob
5. Low Batt. (Low Battery LED Light)
6. Tuner on/off Button
7. Battery box
Specification
Features :
2Band EQ with Chromatic LED tuner
Input Impedance :
22 MΩ
Frequency Response :
Control Range
Bass :
+/-12dB at 100Hz
Treble :
+/-12dB at 10KHz
Battery Status LED
Power Supply :
2 X CR2032 Coin Battery
Battery Life
Only Eq :
Over 200Hours
Tuner on :
Over 100Hours
Pick-up :
Omega II Piezo Cable pick-up
Dimension :
W 56mm X H 40mm (2.2" X 1.6")
4
5
6
7
1
20Hz ~ 20KHz
3
Functions
1. Tuner LED Display
Tuner LED Display
: Tuning Guide LED for Sharp tune
: Tuning Guide LED for right tune
: Tuning Guide LED for flat tune
2. Bass
(for bass tones)
3. Treble
(for high tones)
The BASS, TREBLE controls are a 3-band equalizer for controlling
tone.
The center detent on these tone controls yields a flat tone response.
"+12" boosts the tone; "12"cuts the tone.
4. Volume Knob
The VOLUME controls the output volume. At "0" it is completely OFF.
At "10" it is loud.
5. Low Batt. (Low Battery LED Light)
The LED will light when the battery has lost power. Replace the
battery when this light is on.
This LED light will flash when a cable is connected to the output
jack of the pickup system. This shows the battery is good.
6. Tuner on/off Button
Power switch of built-in Chromatic LED tuner.
Automatic power off after 5 minutes
7. Battery box
2 X CR2032 Coin Battery
Caution
- The jack should be pluged for proper Preamp working.
(TUNER will works regardless pluging jack)
- There is no output sound, please check if tuner or mute is turned on.
- When LCD screen is dim or no display, please check battery life.
- To prevent battery loss, please unplug jack when preamp is not in use.
- Do not disassemble for repair.
Return to your dealer for service or repair.
- Do not use too much force when operating the control.
2
4