Audiopax 5 Manuel - Sayfa 7

Amplifikatör Audiopax 5 için çevrimiçi göz atın veya pdf Manuel indirin. Audiopax 5 10 sayfaları.

Turning on your Model 5

When Model 5 power is turned on by using the power on/off switch of the power

supply, the front LED of the power supply should light but not the front LED on the

preamplifier, as it remains for 40 seconds in its previous state (switched to bypass

input). After this period (and with the front panel switch on standby on) the preamplifier

led will also light up and the input will be switched according to the front panel

selection.

As initial setup we recommend the following positions:

● Put the Power Supply Unit rear switch to its "grounded" position. The

ungrounded position should only be used to test for potential system

grounding problems that may cause noise (such as "ground loops"), that

is, even if its use apparently resolves some kind of problem, it is

important that the original electrical problem be corrected to allow you to

return this switch to its normal (grounded) position.

● Put the "Gain" switch on the back of the preamplifier to high.

● Put "cd in" switch on the back of the preamplifier for unbalanced for the

use of RCA input cables or balanced for the use of XLR input cables.

● Put Timbre Lock

position.

● Be sure that the "Standby on/off" switch at the preamp is in its off position

before connecting the power supply.

It is also always recommended that the preamplifier be turned on before the

power amplifiers.

potentiometers and volume at minimum (zero)