audiophony Ti154 Kullanıcı Kılavuzu - Sayfa 5

Amplifikatör audiophony Ti154 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. audiophony Ti154 12 sayfaları. 4-channel 4x150w amplifier at 4 ohms

Sayfayı Yazdır

Ti154 - 4-channel 4X150W amplifier at 4 Ohms

1 - Description

Front panel

[1] - Mounting brackets

Allow you to install your amplifier within 19" (482mm) racks..

[2] - Power button

[3] - Indicator LEDs

Signal LED:

This green and yellow LED lights up when a signal is

detected via one of the input.

Clip LED: Lights up when the clip threshold has been

reached to indicate the input is saturated and its output

signal might be distorted.

Adjust the level output of your source in order

to correct this and prevent damages to your

speaker and amplifier. The sound quality will

drastically improve as well.

Protect LED: Lights up to indicate the

channel is in protection mode, the output will then be

"cut" by an internal relay.

Usually the Protect mode is activated when the channel

is overheating or serious problems occur in

order to protect speaker(s) connected to this

channel.

This LED briefly lights up upon activation

of your amplifier in order to avoid sending

voltage peaks to your speakers during the initialisation of

your amplifier.

[4] - Input attenuator

Each channel features its own input attenuator allowing you

to limit the incoming signal level.

This attenuator has 21 different levels. When on the left, the

signal is attenuated by 80 dB, when on the right the signal

is not attenuated and the amplifier operates at full power. In

mono bridged mode, attenuator 1 affects both channels.

In Parallel mode, each attenuators only affects its own

channel.

English

Page 5